Hi Rancher ABH Load Bars
Section 1 Unboxing
- Black Nylon Bag
- M10 Hexagon Bolt set *4
- M10 Anchor Bolt *8
- Hex key
- Load Bars*2
Section 2 Weighing System
The weighing system consists of a weight indicator and two load bars which install under the platform or chute.
(Tips: you may also need adaptor plates for your chute.)
Section 3 Testing
Must test with a weighing indicator.
Step 1.
Put a test weight(which may be yourself or another people) at one end of the platform/crate and note the stable reading on the indicator
Step 2.
Take the weight off, and put on the other end of the platform/crate and note the stable reading on the indicator.
Step 3.
Remove the test weight and note whether the reading returns to zero.
Step 4.
If the two readings differ by more 2% of capacity or the reading does not return to zero,see the troubleshooting section.
Tips: During use, if the device has not been used for a period of time, repeat the above test before using it for the first time.
Section 4 Use Assembly
Step 1.
Select a horizontal and firm ground for the load bars
(Tips：Must installed on a horizontal ground in order to weigh accurately)
Step 2.
Uplift one side of platform or squeeze chute then put the load
bar below, align the load bars mounting holes with platform or
squeeze chute holes,get out the M10 bolts in the accessories
package ,screw them up with the wrench
Step 3.
Repeat step two for the other side
Step 4.
Secure the foot plate to the ground with anchor bolts*8
Step 5.
Connect the load bar to a indicator (e.g fox)
(Tips: Must connect all cables first before turning on indicator, If you turn on advance, the display may not be zero. In that case, press the “ZERO”button to reset to zero.)
E.G Connect Fox Indicator
Step 1.
Hold the black plug and insert it into the hole. We have set up corresponding raised parts and recesses for proper alignment.
Step 2. 
Turn clockwise to tighten.
Step 3.
Tighten the other end in the same manner by turning counter clockwise.
Tips:
- When removing the connector, hold the connector body itself. Do not pull it out by holding the blue cable, as this may cause damage and affect the weighing accuracy.
- After use, cover the connector with the black cap to prevent dust from entering and causing blockages, which may affect precision.
Section 5 Troubleshooting
| Fault | Remedy |
| Reading does not return to zero between animals/Difference in readings at each end of the platform/Under reading(reading lighters than expected) |
|
| Reading is unstable |
|
| Reading moves,display shows underload or overload. |
|
Section 6 Further Information
- Do not leave the indicator ,load bars or plugs immersed in waters.
- Cables should be placed correctly so that will not be damaged.
- Regularly clean up manure and fertilizer buildup around the load bar to ensure weighing accuracy.
An ISO9001 registered company
Room 1912, Building 3, Tiandu Tower, No. 211 Changjiang Road, Suzhou City, Jiangsu
Province, China
Documents / Resources
 | Hi Rancher ABH Load Bars [pdf] User Manual ABH-Muanl.pdf, ABH 25-7, ABH Load Bars, ABH, Load Bars, Bars |