User Manual
Barcode reader with stand
HD10C
Specification
- Light Source: 620nm LED
- Sensor Type: CMOS
- Scanning method: manual (on the button) / automatically (after bringing the code closer)
- Scan Acknowledgement: Light and Sound Signal
- Read Rate: 200 times/second
- Interface: USB
- Cord length: 140 cm
- Ingress protection: IP54
- Device dimensions: 16 x 9.5 x 6.5 cm
- Stand dimensions: 24 x 12 x 12 cm
- Package dimensions: 18.5 x 12 x 8.5 cm
- Device weight: 300 g
- Weight with packaging: 370 g
- Operating temperature: – 20 – 50°C
- Storage temperature: -40 – 60°C
- Readable 1D codes: EAN-8, EAN-13, UPC-A, UPC-E, CODE 128, CODE 39, CODE 93, CODE 11, CHINESE 2 of 5, CODABAR, MSI, Interleaved 2 of 5 (ITF), other one-dimensional
The set includes:
- Barcode Reader
- Self-assembly reader stand
- Built-in USB communication cable
- Manual
Features:
- Wired reader for scanning standard barcodes
- Ability to scan codes displayed on LCD and LED/OLED screens as well as mobile device displays
- Barcode scanning in automatic mode
- Any character before or after the code can be programmed
Factory reset
 Restore default settings | |
| Code Scan Modes | |
 Manual mode |  Auto mode |
| Beep settings | |
 Sound On (Default) |  Sound off |
| Setting End Characters | |
 CR |  No signs |
 TAB |  LF+CR |
| Case settings | |
 Uppercase and lowercase letters |  No case conversion |
 Uppercase letters only |  Lowercase only |
| Reading inverted codes (on black background) | |
 Enabled |  Disabled (default) |
| Adding a prefix and suffix | |
 Add a prefix |  Add a suffix |
 Cancel prefix |  Cancel Suffix |
In order to set a prefix or suffix, first scan the code “Add prefix” or “Add suffix”, then scan the corresponding character from the table at the end of this manual and finally read the code “Save settings”.
Hiding barcode characters
 |  |
| Hiding leading characters | Hide trailing characters |
In order to hide individual characters in the barcode, first scan the code “Hide initial characters” or “Hide end characters” and then use the scanner to read the code at the end of this manual, corresponding to the number of digits to be hidden.
For example, if you want to hide the first two characters of a barcode, first scan the “Hide initial characters” code, then scan the “0” and “2” codes from the table.
Character table
Documents / Resources
 | HDWR Global HD10C Barcode Reader with Stand [pdf] User Manual HD10C, HD10C Barcode Reader with Stand, HD10C, Barcode Reader with Stand, Reader with Stand |