Harman Kardon SoundSticks III 2.1 Speaker System
Introduction
A powered subwoofer with a 6-inch, 20-watt down firing driver. Eight full-range 1-inch transducers. interoperability with almost any multimedia device via plug-and-play. amazing industrial design that flawlessly balances the audio clarity. With the least amount of wire and stunning aesthetics, the Harman Kardon SoundSticks III desktop sound system elevates music, gaming, and movies to a whole new level of excitement.
IMPORTANT SAFETY INSTRUCTIONS
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Do not use this apparatus near water.
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
- Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- Do not expose this apparatus to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the apparatus.
- To completely disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from the AC receptacle.
- The mains plug of the power supply cord shall remain readily operable.
- Do not expose batteries to excessive heat such as sunshine, fire or the like.
SPECIFICATIONS
SYSTEM
- FREQUENCY RANGE: 44Hz – 20kHz
- POWER CONSUMPTION: 4W idle, 65W maximum
SUBWOOFER
- TRANSDUCER (1): 6” woofer
- AMPLIFIER OUTPUT POWER: 20W RMS
- DIMENSIONS (W X H): 9-3/16” x 10-3/16” (232mm x 258mm)
- WEIGHT: 4 lb. (2.2kg)
SATELLITE
- TRANSDUCERS (4): 1” full-range per channel Amplifier output power: 10W RMS per channel
- DIMENSIONS (W X H): 2” x 10” (51mm x 254mm)
- WEIGHT:5 lb. (0.7kg)
- STEP 1. Place individual SoundSticks® III (satellites) beside monitor/computer.
- STEP 2. Place the subwoofer as desired, but placement under your desk will provide optimal performance.
- STEP 3. Connect satellite cables to the dual subwoofer cable. Also, connect the input cable to the subwoofer input cable jack.
- STEP 4. Insert SoundSticks III input cable into the computer or other audio device.
Troubleshooting | ||
| Symptom | Possible problem | Solution |
| No sound from SoundSticks III speaker system. | No power to subwoofer. | Ensure power supply is connected to live power source and is properly connected to subwoofer. Please note: When subwoofer is powered, a power LED should light. |
| Power adapter plug not inserted correctly. | Place plug with arrow symbol facing UP into the subwoofer. | |
| No volume or low volume. | Touch the volume “Up” (+) pad on the volume control satellite to unmute and/or increase the system volume level. | |
| Note: Touching the volume “Down” (–) pad lowers the system volume. Touching both (+) and (–) volume control pads at the same time will mute the system. | ||
These specifications are subject to change without notice.
EASY SETUP GUIDE
- STEP 5. Plug power cord into power adapter.
- STEP 6. Plug power adapter into subwoofer.
- STEP 7. Plug power cord into wall receptacle.
- STEP 8. Push power ON/OFF button. Unit is on when LED is lit. Push the subwoofer volume knob/power ON/OFF button. Unit is on when the LED is lit. Use the subwoofer volume knob to balance the subwoofer’s volume with that of the satellites.
- STEP 9. Adjust volume level by touching + or – button. Touching both the + and – buttons mutes the audio. When muted, touching either button unmutes the audio.
| www.harmankardon.com | ||
| Symptom | Possible problem | Solution |
| No sound from subwoofer, only satellites.
No sound from satellites, only subwoofer. High frequencies sound dull. | Subwoofer volume control set at minimum.
Satellites not connected to subwoofer. Satellites not positioned properly. | Rotate subwoofer volume control clockwise until relative volume level is appropriate.
Check connection of satellites to subwoofer.
Position and tilt (angle) loudspeakers toward listener. The sound from the satellites is very directional due to the four-element linear array design. |
FAQs
Older versions and the 220V adapter worked flawlessly. In 2011, I went on one to Ukraine, and I felt fantastic. It still functions well after I gave it as a gift to a friend.
Yes, the marketing for these speaker systems makes much of the simplicity and simplicity of the line-level cable connection. You’ll be set to go as long as your machine has line-level communication and I’ve never seen a PC audio card without L and R out. The same applies to connecting your phone, mp3 player, and other line-level devices (the 3.5 mm cable plug). That, I think, is the size.
works great, we have 2!
From the subwoofer to your device, you can utilize a normal 3.5mm male to male stereo extension wire. An RCA (composite) cable can be used to extend the left satellite speaker.
Although the sound sticks are stylish, they don’t provide the amount of sound or bass that I prefer. In my opinion, anything is superior to these. It does offer nice highs and mids, but that’s all there is. For the price, there are far better options available.
I’m unsure. The speakers are 1/8 inch “connector for stereo. It ought to function if your TV or converter box offers that kind of audio out. The 1/8 “The stereo jack, like the headphones on an iPhone, is a widely used standard.
I’d advise you to visit eBay and purchase a second-hand set sans the woofer.
Your machine supports two audio system connections. My Harman Kardon Stick III and Bose Companion 50 computer audio systems are both connected to my iMac through a stereo audio splitter connection.
Under the desk, the woofer can be set up on the ground. The speakers and woofer cannot be “mounted” to anything at all.
Measure them—if they are level, it is much more likely that the surface you have them on isn’t level. The base will vibrate excessively if you set it up too high, allowing it to move slightly but not “wobble.”
Absolutely! Simply connect it. However, you’ll need to search elsewhere if wireless connectivity is what you’re after.
It is not wireless, no.
Doubtful, as these need a USB connection to work and a practical way to use that USB connection. They might function if the customer bought some form of adaptor or converter. It is not assured, though.
If your TV has a 3.5mm aux output, you can use a 3.5mm aux cable to connect our Harman Kardon SoundSticks III to it.
I bought this item for usage in the United States and it came ready to connect into one of our typical 110v outlets; I’m not sure how your power system is set up. If your wall outlets are of the “European” variety, an adaptor or transformer could be needed.
