hama logo

00054682 Bluetooth Controller for Nintendo Switch or Switch Lite
Instruction Manual
hama 00054682 Bluetooth Controller for Nintendo Switch or Switch Lite

00 054682
Bluetooth ® Controller 

Quick Guide hama 00054682 Bluetooth Controller for Nintendo Switch or Switch Lite - figController without motion control, no NFC and no infrared function.

Operating Instructions

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Shenzhen K18 Bluetooth headset - Icon Warning This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note This symbol is used to indicate additional information or important notes.

Package contents

  • Bluetooth Controller
  • USB-C charging cable
  • These operating instructions

Safety instructions

  • The product is intended for private, non-commercial use only.
  • Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
  • As with all electrical products, this device should be kept out of the reach of children.
  • Do not drop the product and do not expose it to any major shocks.
  • Do not operate the product outside the power limits specified in the technical data.
  • Do not use the product in areas in which electronic products are not permitted.
  • Be considerate. High volumes can disturb or interfere with your surroundings.
  • Do not open the device or continue to operate it if it becomes damaged.
  • The battery is permanently installed and cannot be removed; dispose of the product as a whole in accordance with the statutory regulations.
  • Keep the packaging material out of the reach of children due to the risk of  suffocation.
  • Dispose of packaging material immediately in accordance with the locally applicable regulations.
  • Do not modify the product in any way. Doing so voids the warranty.

Start-up and operation

Note ­ Pairing the controller

  • Note that the maximum range for Bluetooth® is 10 metres without obstacles such as walls, people, etc.

4.1 Connecting the controller

  • On your Nintendo Switch, open the menu item “Controller” à “Change grip/order”. Now press the Home and B button together.

Note – Automatic disconnection 

  • Be aware that you will need to carry out this procedure each time you log on to the console.
  • Note that the controller automatically loses the connection to the console after 5 minutes of inactivity.

4.2 Charging the battery
Shenzhen K18 Bluetooth headset - Icon Warning ­ rechargeable battery 

  • Only use suitable charging devices or USB ports to charge the product.
  • Do not use defective chargers or USB ports and do not attempt to repair them.
  • Do not store, charge or use the device in extreme temperatures.
  • Charge regularly (at least quarterly) during periods of prolonged storage.
  • Fully charge the controller once before using it for the first time.
  • Connect the supplied USB-C charging cable to the USB-C port on the controller.
  • Connect the free plug on the USB-C charging cable to a suitable USB charger. To do this, consult the operating instructions for the USB charger you are using.
  • During the charging procedure, the player indicator flashes red.
  • If the controller is not connected to the console, all 4 LEDs will flash.

Note ­ charging procedure

  • A complete charging cycle takes about 2.5 hours
  • The controller’s rechargeable battery can be charged both when it is connected and when on standby.
  • If the battery capacity is too low, the player LED will flash, and the vibration function will start
  • Please use the enclosed USB-C cable only for charging the controller.
  • The actual battery life will vary depending on how you use the device, the settings and the environmental conditions (batteries have a limited life).

4.3. Additional keys

  • The following action keys can be assigned to the additional keys: A/B/X/Y/L/R/L2/R2/D-PAD
  • Individual functions or key combinations can be programmed.
  • Your settings will remain active after an interruption to the connection.
  • The programming mode is aborted after 30 seconds.
  • The programming mode is ended after 25 keys.

4.4. Programming the additional keys 

  • Hold the relevant M key and “+” pressed until the four LEDs start to flash alternately.
  • Now enter the individual key or key combination.
  • To finish, press the relevant M key again.
  • To delete the M keys, hold “+” and an M key pressed for one second (LEDs flash slowly).
  • Now press the M key you want to delete the setting from.

Care and maintenance

  • Only clean this product with a slightly damp, lint-free cloth and do not use aggressive cleaning agents.

Turbo function

  • The following action keys can be assigned a Turbo function: A/B/X/Y/L/R/L2/R2
  • To assign the relevant key, press and hold the action key and Turbo key at the same time.
  • To remove the Turbo function, repeat the procedure.
  • Your settings will be reset after an interruption to the connection.

Auto function

  • The following action keys can be assigned the Auto function: A/B/X/Y/L/R/L2/R2
  • To assign the relevant key, press and hold the action key and then press the Turbo key twice.
  • To remove the Auto function, repeat the procedure.
  • Your settings will be reset after an interruption to the connection.

Setting vibration

  • The vibration settings of the controller can be set on three levels.
  • To do this, press the L/R/L2/R2 keys simultaneously for three seconds.

Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

 Technical data

Bluetooth® Controller

Bluetooth® technology Bluetooth® 5.1+EDR
Frequency for the Bluetooth® transmissions 2400 ­ 2483 MHz
Bluetooth® transmission power 0 dBm
Range < 10 m
 Max. connected devices 1
Charging voltage 5 V icon 300 mA

Rechargeable battery

Batt. type 3.7 V Li-Po
Min. capacity 400 mAh / 1.48 Wh
Type Capacity 410 mAh / 2.29 Wh
Charging time Approx. 2.5 hours
Operating time Approx. 12 hours

Declaration of Conformity

CE SYMBOL Hama GmbH & Co KG hereby declares that the radio equipment type [00054682] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity can be found on the following website: www. hama.com -> 00054682 -> Downloads.

Frequency band(s) 2400 – 2483 MHz
Maximum radio-frequency power transmitted 0 dBm

hama logoHama GmbH & Co KG
86652 Monheim / Germany
www.hama.com
Service & Support
icon www.hama.com
ACONIC AC FLS20 LED Light Up Wireless Water Resistant Shower Speaker - icon 1+49 9091 502-0 DG

hama 00054682 Bluetooth Controller for Nintendo Switch or Switch Lite - icon
22 PAP Raccolta Carta The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by Hama GmbH & Co KG is under license. Other trademarks and trade names are those of their respective owners. All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and subject to technical changes. Our general terms of delivery and payment are applied.

Documents / Resources

hama 00054682 Bluetooth Controller for Nintendo Switch or Switch Lite [pdf] Instruction Manual
00054682, Bluetooth Controller for Nintendo Switch or Switch Lite, 00054682 Bluetooth Controller, 00054682 Bluetooth Controller for Nintendo Switch or Switch Lite

References

Leave a comment

Your email address will not be published.