CyberPower UPS Systems, Battery Backup, PDUs, USB Surge ProtectorsSupport | CyberPower
P65Warnings.ca.govCyberPower UPS Systems, Battery Backup, PDUs, USB Surge ProtectorsSupport | CyberPowerP65Warnings.ca.gov
User Manual for CyberPower models including: GC206UC 2 Outlet Surge Protector, GC206UC, 2 Outlet Surge Protector, Surge Protector, Protector
GC206UC - 2 Outlet Surge Protector Extension Cord With USB - Product Details, Specs, | CyberPower
GC206UC | User Manual | CyberPower
File Info : application/pdf, 1 Pages, 289.99KB
DocumentDocumentYOUR ULTIMATE ALLY IN POWER 2-OUTLET SURGE PROTECTOR (2 AC OUTLETS & 2 USB PORTS) GC206UC USER MANUAL 1 2 3 4 Cyber Power Systems (USA), Inc. 4241 12th Avenue East, Suite 400 | Shakopee, MN 55379 CyberPowerSystems.com FEATURES 1 . USB-A Charging Port (1) 2 . USB-C Charging Port (1) 3 . Standard Grounded Outlets (2) 4 . Braided Power Cord SURGE PROTECTOR INSTRUCTIONS 1 . Plug the surge protector into a standard grounded wall outlet by fully inserting the plug. 2 . Make sure electronic equipment is turned o~ before plugging into the surge protector outlets. 3 . Do not use extension cords or power strips to connect equipment to the surge protector. SPECIFICATIONS Model Number: GC206UC Outlets: Standard Grounded Outlets (2), USB Charging Ports (2) Surge Protection: 400 Joules USB-A Charging Output: 5 V/2.4 A USB-C Charging Output: 12W USB Output Total: 12W (shared) Electrical Rating: 125 V/13 A/60 Hz/1675 W i WARNING: This product can expose you to chemicals including Styrene, which are known to the State of California to cause cancer, and Bisphenol A (BPA), which are known to the State of California to cause birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK: Use only in dry locations and only indoors. DO NOT plug into another relocatable power tap. DO NOT "daisy chain" surge protectors. DO NOT use with any aquarium equipment. DO NOT use if properly grounded outlets are not available. DO NOT install this device if there is less than 10 meters (30 feet) of wire between the electrical outlet and electrical service panel. DO NOT use for medical or life support equipment. This device features an internal protection that will disconnect the surge protective component at the end of its useful life, but it will maintain unprotected power to the load. FOR MORE INFORMATION Visit CyberPowerSystems.com for more information regarding: · Product information and certifications · Product warranty · Connected equipment guarantee TECHNICAL SUPPORT Visit: CyberPowerSystems.com/support Toll-Free: 1-877-297-6937 © 2024 Cyber Power Systems (USA), Inc. All rights reserved. All other trademarks are the property of their respective owners. CONFORMANCE APPROVALS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and o~, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit di~erent from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.