global sources J50 Bluetooth Receiver User Manual
Packing List
- Bluetooth Receiver*1
- 3M Film 2
- Manual 1
Product Diagram
Fixed Method
- Remove the protective film.
- Stick the Bluetooth receiver on the dashboard.
Pairing Operation
- Insert the USB connector of the receiver into a power supply, the light ring will light up which means the receiver is turned on.
- Plug the 3.5mm audio cable of the receiver into the 3.5mm AUX port of the car audio system.
- Turn the phone’s Bluetooth function on, search for the Bluetooth device “J50”, click to pair and connect with it.
- After connecting successfully, you can start to use the receiver to enjoy music or answer calls.
Operation Instructions
- Music function
Play/Pause:
Click the play/pause button
Volume Up:
Click/Long Press the volume up button
Volume Down:
Click/Long Press the volume down button
Previous:
Click the previous button
Next:
Click the next button
- Voice assistant
Press and hold the call button for 2s, and then release after hearing a “doo-doo-doo-doo” sound - Call function
Answer Call:
Click the call button
End Call:
Click the call button
Reject Call:
Press and hold the call button for 2s
Redial Last Number:
Double-click the call button
- Factory reset
Restore Factory Settings:
Under turned on status, press and hold the”+” and”-” buttons simultaneously for 5s
Indicator instructions
Ready for Pairing: The light ring flashes slowly in breathing mode
Pairing Successfully: The light ring keeps on
Turn Lights On/Off: Press and hold the “Next” button for 3 seconds. to manually turn off/on the lights
Restore Factory Settings: LED stays on for 1S and then turns to breathe
Prompt tone instructions
Volume Up: Raise it to the loudest and it will “doo-doo”
Volume Down: Reduce the volume to the maximum and it will “doo-doo”
Connected: “doo” sound
Restore Factory Settings: “doo-doo-doo-doo”
Activate Voice Assistant: “doo-doo-doo-doo”
Why doesn't it play sound after connecting Bluetooth?
Please try switching the AUX button on the car.
Why can't the receiver be turned on when connected with power?
A:The USB charging port and cable may not be connected properly, please pull the cable out and plug it in again repeatedly to make sure it is well inserted. Please use adapters or car chargers that conform to national/ regional safety standards to supply power for the product. Adapters with excessive power may be incompatible. ③ The product does not support PD protocol, when using PD power adapters to supply power for the product, it may be incompatible.
FCC Compliance Statement:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
<ul>Documents / Resources
 |
global sources J50 Bluetooth Receiver [pdf] User Manual J50, 102015271, J50 Bluetooth Receiver, Bluetooth Receiver, Receiver |
