GEPRC-logo

GEPRC SPAN F722-BT-HD v2 Stack

GEPRC-SPAN-F722-BT-HD-v2-Stack-product-image

SPAN F722 BT-HD v2

  • Target: GEPRC F722-BT-HD v2
  • MCU: STM32F722RET6
  • GYRO: ICM 42688-P
  • Blackbox: 512Mb On-board SD card
  • OSD: AT7456E
  • Barometer: NO
  • BEC SV : 3A
  • BEC12V: 3A
  • Size: 36x36mm, cp4mm
  • Mounting hole: 30.SX30.Smm
  • Input Voltage: 12.6-26.2V
  • Uart: Sset

Supporting adjust parameters by Bluetooth on Speedybee App

GEPRC-SPAN-F722-BT-HD-v2-Stack-1

SPAN 50A ESC v2

  • MCU:  STM32G071(32BIT)
  • Continuous Current: 50A
  • Burst Current:  60A (5s)
  • Bee: NO
  • Current detection: YES
  • Telemery: YES
  • Supports Dshot: lS0-600
  • PWM: 24-96K
  • Target GEPRC-G071
  • Input Voltage: 12.6V-26.2V

GEPRC-SPAN-F722-BT-HD-v2-Stack-2

Bluetooth

GEPRC-SPAN-F722-BT-HD-v2-Stack-3

  1. Connect the FC to the battery
  2. open the Speedybee app
  3. Click the Bluetooth icon on the screen
  4. once you have found “CEPRC F7” click Connect
  5. For your safety, please remove the propeller before Plug in the battery to adjust the FC parameters

Speedy Bee App download link https://www.speedybee.com/speedy-bee-app/ Or
scan the QR code below to download

DJI FPV digital system

GEPRC-SPAN-F722-BT-HD-v2-Stack-4

Analog VTX

GEPRC-SPAN-F722-BT-HD-v2-Stack-5

Receiver: TBS/ELRS

GEPRC-SPAN-F722-BT-HD-v2-Stack-6

Receiver: R-XSR

GEPRC-SPAN-F722-BT-HD-v2-Stack-7

GPS

GEPRC-SPAN-F722-BT-HD-v2-Stack-8

Buzzer& LED Board

Include

  • 1 x SPAN F722-HD-BT FC
  • 1 X SPAN GSOA BLHeli_32 SOA ESC 1 x XT60-11CM-14AWG Cable
  • 4 x M3x30mm screw
  • 4 x M3 x2Smm screw
  • B x M3 Nylon nut
  • 1 x 35V 680UF Capacitor
  • 1 x SHl,0 8Pin Cable
  • 1 x SHl.O to GH 1.25 6Pin cable
  • 10 x M3*8 damping rings

Documents / Resources

GEPRC SPAN F722-BT-HD v2 Stack [pdf] User Manual
SPAN F722-BT-HD v2 Stack, SPAN F722-BT-HD v2, Stack

Leave a comment

Your email address will not be published. Required fields are marked *