Instructions for 3D models including: 24 UP LC250, Prado Flat Switch Panel Mount, LC250 Prado Auxiliary Switch Panel, Prado Auxiliary Switch Panel, Auxiliary Switch Panel, Switch Panel
24 UP LC250/Prado Flat Switch Panel Mount (1958 Only) – ObiSan 3D Installation instructions can be found
LC250/Prado Auxiliary Switch Panel Installation Instructions 1. Remove the side panel from the center console pad by pushing outwards to release the factory clips. 2. Remove the plastic panel between the center console and the glove compartment door. 3. Dislodge the right side of the center console trim to access the factory switch plate. 4. Remove the factory switch plate by pressing outwards. 5. Disconnect any factory switches from their harnesses. 6. Transfer the factory switches and install your aftermarket OEM-style switches to the new switch panel. 7. Use the included blanks for any unused switches. 8. ***CAUTION*** To remove the panel once installed, make sure it is pulled straight out. Do not attempt to remove the panel in the same manner as the OEM one. The tabs will break if an attempt to pry out the panel at an angle. If the tabs break, the square pad molded into the back of the panel can be used to remount the panel with double sided tape.Microsoft: Print To PDF