garth Fascia Replace Instructions

garth Fascia Replace

Product Information

The product is a fascia replacement for a specific device. The fascia is the front panel of the device that often contains control knobs and buttons. This user manual provides step-by-step instructions on how to replace the fascia.

Product Usage Instructions

1. Step 1: Remove the regulator as shown in the image.
2. Step 2: Take out all the knobs.
3. Step 3: Remove all screws from the knob bezel.
4. Step 4: Take out the side burner injector nut as shown in the picture.
5. Step 5: Take out the bolts as shown in the picture.
6. Step 6: Take out the bolts as shown in the picture.
7. Step 7: Gently draw the fascia out.
8. Step 8: Replace with a new fascia.
9. Step 9:
   1. Reverse steps above to re-install the parts. Please pay attention when installing the fascia so that each injector on the manifold coincides with the burner inlets.
   2. Conduct a leak test for the regulator.

How to replace the fascia

• Step 1:
  Remove the regulator as shown in the image.
• Step 2:
  Take out all the knobs.
• Step 3:
  Remove all screws from the knob bezel.
• Step 4:
  Take out the side burner injector nut as the picture shows on.
• Step 5:
  Take out the bolts as the picture shows.
• Step 6:
  Take out the bolts as the picture shows.
• Step 7:
  Gently draw the fascia out.
• Step 8:
  Replace with a new fascia.
• Step 9:
  • A. Reverse steps above to re-install the parts. Please pay attention when installing the fascia so that each injector on the manifold coincide with the burner inlets.
  • B. Conduct a leak test for the regulator.