Lámhleabhar Úsáideora Rialaitheoir Muirear Gréine EPEVER PWM-VS1024AU Sraith AU

Doiciméad

PWM-VS1024AU AU Series Solar Charge Controller

BEIJING EPSOLAR TECHNOLOGY CO., LTD.
Go raibh maith agat as a roghnú ViewStar AU series solar charge controller. Please read this manual carefully before using the product.
ViewRialaitheoir muirear gréine sraith Star AU
1. Tharview
Go raibh maith agat as an ViewStar AU series common positive solar charge controller. The VS-AU controller is a PWM charge controller with built in LCD display that adopts the most advanced digital technique. The multiple load control modes enable it can be widely used on solar home system, traffic signal, solar street light, solar garden lamp, etc. The features are listed below: Adopt high quality components of ST,IR and Infineon, make sure product using lifespan Terminals have UL and VDE certification, the product is more safer and more reliable Controller can work continuously at full load within the environment temperature range
from -25 to 55 3-Stage intelligent PWM chargingBulk, Boost/Equalize, Float Support 3 charging options: Sealed, Gel, and Flooded LCD display design, dynamically displaying device’s operating data and working
condition Double USB design, the power supply charge for electronic equipment With humanized button settings, operation will be more comfortable and convenient Multiple load control modes Energy statistics function Battery temperature compensation function Extensive Electronic protection
2. Gnéithe Táirgí

Fíor 1 Saintréith

LCD

Teirminéil Ceallraí

Cnaipe MENU

Teirminéil Luchtaithe

Port RTS

Cnaipe SET

Teirminéil PV

Calafoirt Aschuir USB

USB output ports provide the power supply of 5VDC/2.4A and have the short

circuit protection.

Cúlpháirtí Roghnach:

Name: Remote Temperature Sensor

Model: RTS300R47K3.81A

Acquisition of battery temperature for undertaking temperature compensation of control parameters, the standard length of the cable is 3m (length can be customized). The RTS300R47K3.81A connects to the port on the controller.

NOTE: Unplug the RTS, the temperature of battery will be set to a fixed value 25ºC.

3. Sreangú

Tel+86-10-82894112 / 82894962 Websitewww.epsolarpv.com/www.epever.com
(3)The battery fuse should be installed as close to battery as possible. The suggested distance is within 150mm.
(4) The VS AU series is a positive ground controller. Any positive connection of solar, load or battery can be earth grounded as required.
NOTE: Please connect the inverter or other load that it has the large start current to the battery rather than to the controller, if the inverter or other load is necessary.
4. Oibríocht

4.1 Feidhm Cnaipe
Button MENU button
Cnaipe SET
4.2 Taispeántas LCD

Feidhm
Browse interface Setting parameter
Load ON/OFF Clear error Enter into Set Mode Save data

Status Description Item
Eagar PV
Battery
Load Browse interface

Deilbhín

Status Day Night No charging Charging PV Voltage, Current ,Power Battery capacity, In Charging Battery voltage. current, temperature Battery type Load ON Load OFF Load Voltage, Reatha, Mód luchtaithe

NÓTA
1 When no operation, the interface will be automatic cycle, but the follow two interfaces
not be display.

Figure 2 Connection diagram (1) Connect components to the charge controller in the sequence as shown above and pay much attention to the “+” and “-“. Please don’t insert the fuse or turn on the breaker during the installation. When disconnecting the system, the order will be reserved.
(2)After power on the controller, check the LCD on. Otherwise please refer to chapter 6.Always connect the battery first, in order to allow the controller to recognize the system voltage.
1

2 Accumulative power zero clearing: Under PV power interface, press SET button and hold on 5s then the value blink, press SET button again to clear the value.

3 Setting temperature unit: Under battery temperature interface, press SET button and hold on 5s to switch.

Léiriú lochtanna

stádas

Deilbhín

Tuairisc

Ceallraí ró-urscaoilte

Léiríonn leibhéal ceallraí folamh, blink fráma ceallraí, blink deilbhín locht

Ceallraí thar voltage

Taispeánann leibhéal ceallraí iomlán, blink fráma ceallraí, blink deilbhín locht

2

BEIJING EPSOLAR TECHNOLOGY CO., LTD.

Róthéamh Ceallraí

Léiríonn leibhéal ceallraí luach reatha, blink fráma ceallraí, blink deilbhín locht

Teip luchtaithe

Load overload ,Load short circuit

When load current reaches1.02-1.05 times 1.05-1.25 times, 1.25-1.35 times and
1.35-1.5 times more than nominal value, controller will automatically turn off loads in 50s, 30s,10s and 2s respectively

4.3 Socrú mód luchtaithe

Operating Steps: Under load mode setting interface, press SET button and hold on 5s till the number begin flashing, then press MENU button to set the parameter, press SET button to confirm.

Uaineadóir 1

Uaineadóir 2

Solas AR / Off

Díchumasaithe

Load will be on for 1 hour

Load will be on for 1 hour

since sunset

roimh éirí na gréine

Load will be on for 2 hours

Load will be on for 2 hours

since sunset

roimh éirí na gréine

Load will be on for 313

hours since sunset

Load will be on for 313

hours before sunrise

Beidh an t-ualach ar siúl ar feadh 14 uair ó luí na gréine

Beidh an t-ualach ar siúl 14 uair an chloig roimh éirí gréine

Load will be on for 15 hours

Load will be on for 15

since sunset

hours before sunrise

Modh tástála

Díchumasaithe

Manual mode(Default load ON)

Díchumasaithe

NOTE: Please set Light ON/OFF, Test mode and Manual mode via Timer1. Timer2 will be disabled and display “2 n”.

4.4 Cineál Ceallraí
Céimeanna Oibriúcháin

Under Battery Voltage interface, press SET button and hold on 5s then enter into the interface of Battery type setting. After choosing the battery type by pressing MENU button, waiting for 5s or pressing SET button again to modify successfully.

Cineál Battery

Tel+86-10-82894112 / 82894962 Websitewww.epsolarpv.com/www.epever.com

Controller Overheating Load Short Circuit
Ró-ualach Luchtaithe
RTS damáiste

Temperature sensor is higher than 85 Temperature sensor is less than 75 Load current 2.5 times rated current One short circuit, the output is OFF 5s Two short circuit, the output is OFF 10s Three short circuit, the output is OFF 15s Four short circuit, the output is OFF 20s Five short circuit, the output is OFF 25s Six short circuit, the output is OFF
Load current 2.5 times rated current 1.02-1.05 times, 50s, 1.05-1.25 times, 30s 1.25-1.35 times,10s 1.35-1.5 times 2s
Tá an RTS gearrchiorcad nó damáiste

Output is OFF Output is ON
Output is OFF Clear the fault: Restart the controller or wait for one night-day cycle (night time>3 hours).
Output is OFF Clear the fault: Restart the controller or wait for one night-day cycle (night time>3 hours). Charging or discharging at 25

6. Fabhtcheartú

Faults The LCD is off during daytime when sunshine falls on PV modules properly
Wire connection is correct, LCD not display
Blink comhéadan
Blink comhéadan
Blink comhéadan

Cúiseanna féideartha

PV

eagar

dícheangal

1) Ceallraí voltage is lower than 9V 2) PV voltagTá e níos lú ná toirte ceallraítage

Ceallraí thar voltage
Ceallraí ró-urscaoilte
Róthéamh Ceallraí

Fabhtcheartú
Deimhnigh go bhfuil naisc sreinge PV ceart agus daingean
1) Please check the voltage of battery. At least 9V voltage to activate the controller 2) Check the PV input voltage which should be higher than battery’s Check if the battery voltage is higher than OVD point (over voltage dícheangail voltage), and disconnect the PV. When the battery voltagcuirtear e ar ais go pointe LVR nó os a chionn (vol ísealtage athnasc voltage), the load will recover The controller will automatically turn the system off. But while the temperature decline to be below 50 ºC, the controller will resume.

Sealed (Default)

Glóthach

Tuilte

NOTE: Please refer to the battery voltage parameters table for the different battery

cineál.

5. Protections

Blink comhéadan
8. Séanadh

Over load or Short circuit

Please reduce the number of electric equipments or check carefully loads connection.

Cosaint
PV Reverse Polarity Battery Reverse Polarity Battery Over Voltage Battery Over Discharge
Róthéamh Ceallraí

Coinníollacha
When the battery is correct connecting, the PV can be reversed. When the PV is not connecting, the battery can be reversed.
An ceallraí voltage reaches to the OVD

stádas
The controller is not damage
Stop a mhuirearú

An ceallraí voltage reaches to the LVD
Temperature sensor is higher than 65 Temperature sensor is less than 55

Stop ag scaoileadh
Output is OFF Output is ON

Níl feidhm ag an mbarántas seo faoi na coinníollacha seo a leanas:
1) Damage from improper use or use in an unsuitable environment. 2) PV or load current, voltage or power exceeding the rated value of controller. 3) The controller is working temperature exceed the limit working environment temperature. 4) User disassembly or attempted repair the controller without permission. 5) The controller is damaged due to natural elements such as lighting. 6) The controller is damaged during transportation and shipment.

Sonraíochtaí 7.Teicniúla

Mír

VS1024AU

VS2024AU

VS3024AU

VS3048AU

VS4524AU

VS4548AU

Córas ainmniúil voltage Battery input voltagraon e

Auto 12 / 24VDC
9V32V

12/24/36/48VDC Auto
9V64V

Auto 12 / 24VDC
9V32V

12/24/36/48VDC Auto
9V64V

Sruth luchtaithe / urscaoilte reatha [ríomhphost faoi chosaint]

[ríomhphost faoi chosaint]

[ríomhphost faoi chosaint]

[ríomhphost faoi chosaint]

Max. Ciorcad oscailte PV voltage

50V

96V

50V

96V

Battery type Equalize Charging Voltage Treisiú Muirearú Voltage Táillí Snámhphointe Voltage

Sealed(Default) / Gel / Flooded Sealed:14.6V/ Gel: No/ Flooded:14.8V Sealed:14.4V/ Gel:14.2V/ Flooded:14.6V
Séalaithe / Glóthach / Tuilte: 13.8V

Íseal Voltage Athcheangail Voltage

Séalaithe / Glóthach / Tuilte: 12.6V

Íseal Voltage Dínasc Voltage

Séalaithe / Glóthach / Tuilte: 11.1V

Self-consumption Temperature compensation coefficient

9.2mA/12V;11.7mA/24V; 14.5mA/36V;17mA/48V -3mV//2V25

Ciorcad luchtaithe voltage drop Ciorcad urscaoilte toirtetage drop LCD temperature range

0.29V 0.16V -20+70

Working environment temperature Relative humidity Enclosure

-25+55(Product can work continuously at full load)
95%, N.C. IP30

Grounding USB output Overall dimension

142x85x41.5mm 160×94.9×49.3mm

Dearfach Coiteann

5VDC / 2.4A (Iomlán)

181 100.9 × × 59.8mm

194 118.4 × × 63.8mm

Toise gléasta

130x60mm

148x70mm

172x80mm

185x90mm

Mounting hole size Terminals

4.5mm 4mm2/12AWG 10mm2/8AWG

5mm 16mm2/6AWG

5mm 16mm2/6AWG

Meáchan glan

0.22kg

0.35kg

0.55kg

0.58kg

0.76kg

0.88kg

Above the parameters are in 12V system at 25, twice in 24Vsystem, triple in 36V system and quadruple in 48V system.

VS6024AU

VS6048AU

12 / 24VDC

12/24/36 / 48VDC

Auto

Auto

9V32V

9V64V

[ríomhphost faoi chosaint]

50V

96V

214 128.7 × × 72.2mm

205x100mm

5mm 25mm2/4AWG

1.02kg

1.04kg

Athruithe ar bith gan fógra roimh ré! Leagan uimhirV1.2

3

4

Doiciméid / Acmhainní

EPEVER PWM-VS1024AU AU Series Solar Charge Controller [pdf] Lámhleabhar Úsáideora
PWM-VS1024AU AU Series Solar Charge Controller, PWM-VS1024AU, AU Series Solar Charge Controller, Solar Charge Controller, Charge Controller, Controller

Fág tagairt

Nach mbeidh do sheoladh r-phoist a fhoilsiú.