G-MAC Glide Evo Modular Helmet
Anatomy of Helmet
- 1. Chin Bar Mechanism
2. Drop Down Sun Visor (DVS)
3. Micrometric Buckle
4. DVS Thumb Slider - 5. Intercom Recess Cover
6. Visor Release Mechanism
7. Anti-Scratch Visor
8. Air Vents
Pull on the flip mechanism and lift up the chin of the helmet 
Push the chin all the way up until it snaps into place and stay up on its own 
To close the chin bar, pull firmly from the bottom of the chin and close, until you hear an audible locking sound 
DVS SLIDER 
DVS SIDE VIEW 
Slide the DVS slider back and forth to raise and lower your inner sun visor.
NOTE:
Do not manually raise and lower the visor with your hands, always use the slider to prevent damage.
To close the chinstrap fastener, slide the ratchet tongue into the locking buckle. When adjusting, make sure the strap rests firmly but not uncomfortable around your chin. To open the strap, pull the red ribbon of the ratchet upwards to release the buckle. Then pull the other side out.
Instruction For Use And Feature
To remove the visor, first, fully open it 
Press down on the spring-loaded arm and the visor will pop out off of the mechanism 
Once both sides have popped out, remove the visor
To reinstall the visor follow these steps in reverse 
Additional Features
The switch that is uncovered when the chin bar is raised can be used to lock the chin in the upright position. 
The intercom recess cover can be removed to allow the passthrough of cables to inside the helmet body. 
Documents / Resources
 | G-MAC Glide Evo Modular Helmet [pdf] User Manual Glide Evo Modular Helmet, Glide Evo, Glide Evo Helmet, Modular Helmet, Helmet |
