100W KICKSTAND SOLAR PANEL WITH
PWM BUNDLE KIT
MODEL: FSPK10MWT-BL
USER MANUAL
Content Includes:
- 100W Solar Panel
- 10A PWM Charge Controller
- User Manual
- Warranty Manual
* Product picture for reference only
!!ATTENTION!!
- DO NOT use around open flammable sources.
- DO NOT sit on this product.
- DO NOT hang anything from this product.
- DO NOT set up on elevated surfaces (roofs, tables).
- DO NOT hang from elevated supports (trees, ladders).
- DO NOT set up on uneven surfaces/terrains.
- DO NOT set up or place wiring in any standing water.
- DO NOT place wiring in travel paths (walking, vehicle).
- DO NOT place panels in shaded areas (RV, trees, etc.).
- ONLY use this product as intended, with Furrion products, any modification will void the warranty.
SETUP AND OPERATION
NOTE: Ensure the panel has a stable footing.
CONNECTION
Charge Furrion ePod™ Power Station
Connect solar panel directly to Power station DC input (with battery installed – see ePod power station manual for charging)
Charge Furrion eRove™
Connect solar panel directly to eRove cooler solar input (with battery installed – see above manual for charging)
Charge 12V Battery
- Connect solar panel directly to 10A PWM charge controller (provided).
- Connect the controller to Furrion® solar inlet.
- Setup controller and charge.
SETUP 10A PWM CHARGE CONTROLLER
10A PWM Charge Controller Status Indicators
| LED indicators | Indications | Status | Functions |
 |
Charging | Solid on | Solar panel has voltage |
| Solid off | Solar panel has no voltage | ||
| Slow flashing | Charging in process | ||
| Quick flashing | System overvoltage | ||
 |
Battery | Solid on | Normal battery function |
| Solid off | Battery is not connected | ||
| Slow flashing | Battery is under voltage | ||
| Quick flashing | Battery is over-discharged |
Battery Type Selection Method
- Press the button for 3 seconds. The LED will begin to flash indicating that the mode can be changed.
- The LED number will cycle from 1 to 4 when the button is pressed.
- When the desired battery type number appears, wait until the LED stops flashing or press the button again for 3 seconds to complete the setting.
Numeric | Battery Type | Numeric Indicator | Battery Type |
1 | Sealed lead-acid batteries | 3 | Flooded lead-acid batteries |
2 | GEL lead-acid batteries | 4 | Lithium iron phosphate batteries |
HANDLING AND ROUTINE MAINTENANCE
- ALWAYS carry the product by lifting handle.
- ALWAYS keep the glass clean to maximize efficiency.
- ALWAYS lock folding legs in position with turn knob.
- ALWAYS check wiring and connector quality.
- ALWAYS protect glass surfaces when handling/storing.
- ALWAYS maintain batteries as per manufacturer.
CLEANING INSTRUCTIONS
- ONLY use warm soapy water and a clean cloth.
- NEVER use acidic solutions as they may frost/damage the glass.
SPECIFICATION
Mechanical Specifications | |
| Solar Cell Type | Monocrystalline |
| Cell Size | 61/8” x 61/8” (156mm x 156mm) |
| Product Size | 344/16” x 266/16” x 17/16” (870mm x 670mm x 35mm) |
| Number of Cells | 20 |
| Weight | 17.6lbs (8.0kg) ± 10% |
| Cable Length | 1811/8” (4.6m) |
| Type of Connector | DC Connector |
| Junction Box | IP65 rated (dustproof, water-resistant) |
Working Specifications | |
| Power Tolerance | -5%, +5% |
| Operating Temperature | -40°F – 185°F (-40°C – 85°C) |
| Max System Voltage | 30V |
| Max Series Fuse Rating | 15A |
| Normal Operating Cell Temperature | 113±3.6°F (45±2°C) |
| Electrical Specifications ( Standard Testing Conditions=25°C, 1000W/m2 irradiance and AM=1.5) | |
| Max System Voltage (IEC/UL) | 600V |
| Maximum Power Pmax | 100W |
| Power Tolerance | ±5% |
| The voltage at Maximum Power Point Vmp | 17.0V (±4V) |
| Current at Maximum Power Point Imp | 5.92A (±2A) |
| Open Circuit Voltage Voc | 20.9V (±4V) |
| Short Circuit Current Isc | 6.13A (±2A) |
| Cell Efficiency (%) | 21.0% (±5%) |
| Module Efficiency (%) | 17.15% (±5%) |
| Temperature Coefficient of Voc | -0.08%/°F (-0.30%/°C) per degree above 77°F (25°C) |
| Temperature Coefficient of Isc | +0.02 %/°F (+0.06%/°C) per degree above 77°F (25°C) |
| Temperature Coefficient of Pmax | -0.11 %/°F (-0.41%/°C) per degree above 77°F (25°C) |
Furrion Innovation Center & Institute of Technology
● 52567 Independence Ct., Elkhart, IN 46514, USA
● Toll free:1-888-354-5792
● Email: support@furrion.com
©2007-2020 Furrion Ltd. Furrion® and the Furrion logo are trademarks licensed for use by Furrion Ltd.
and registered in the U.S. and other countries.
FURRION.COM
Documents / Resources
 | FURRION FSPK10MWT-BL 100W Kickstand Solar Panel with PWM Bundle Kit [pdf] User Manual FSPK10MWT-BL, 100W Kickstand Solar Panel with PWM Bundle Kit |
