FUNPOWER FT366YG Remote Controller User Manual

Operation Instructions

• ① LED Indicator: Displays status of key presses and battery levels.
• ② Speed of the Fan: Adjusts the rotation speed of the fan.
• ③ Color temperature switching: Alternates between light color settings.
• ④ Fan OFF: Powers down the fan.
• ⑤ Fan Forward/Reverse: Toggles direction of rotation (summer/winter modes).
• ⑥ Light ON/OFF / Light dimming: Controls the light state and holds to adjust brightness.
• ⑦ Learning button: Used to pair the transmitter with the receiver.
• ⑧ O/D Switch:
  • O: Direct control
  • D: Control after learning/pairing
• ⑨ BATTERY: Requires AAA / 1.5V x 2 batteries.

1. If the LED indicator does not light up when a button on the transmitter is pressed, please check the battery installation and alignment.
2. If the LED indicator flashes when a key is pressed, it indicates low battery voltage. Please replace both batteries with new ones.
3. Please remove the batteries from the transmitter if it will not be used for an extended period of time.

Maintenance and Cleaning:

• Clean the remote controller surface using a soft, dry cloth.
• Do not allow water or cleaning liquids to enter the internal components.
• Keep the buttons and battery compartment free from dust.
• Remove the battery if the controller will not be used for a long period.
• Store the remote in a dry location away from heat and moisture.
• Avoid dropping or applying excessive pressure to the controller.

FCC Instructions:

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the product and receiver.
• Connect the product into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.

IC Caution:
RSS-Gen Issue 5 & RSS-Gen numéro 5This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

• This device may not cause interference.
• This device must accept any interference, including interference that may cause undesired operation of the device.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF Exposure Statement:
The equipment complies with the IC Radiation exposure limit set forth for an uncontrolled environment.