Instruction Manual for SKYWALKER RC models including: X8 2120mm Wingspan EPO FPV RC Airplane Flying Wing Kit, X8, 2120mm Wingspan EPO FPV RC Airplane Flying Wing Kit, EPO FPV RC Airplane Flying Wing Kit, Airplane Flying Wing Kit, Flying Wing Kit, Wing Kit
Skywalker X8 2120mm Wingspan EPO FPV RC Airplane Flying Wing KIT – Best Deals English Manual,
4 mai 2024 — use the tube as a guide, align and glue it.After gluing, you can butt the wing to make a trial of the accuracy, insert the extending into the fuselage ...1 page
14+ Skywalker X-8 Installation Manual INSTALLATION DRAWING Thank you for Purchasing the Skywalker X-8 Plane.The skywalker X-8 is designed for First-Person-Vision(FPV) application specifically. Technical parameters. PA R A M E T E R ..B...r.a..n..d..........................s.k..y..w...a..l.k..e..r..r..c... ..M....o..d..e..l.........................................X..8... ..W....i.n..g..s..p..a..n........................2..1...2..0..m...m..... ..F..u...s.e...l.a..g..e...l.e..n..g..t.h.................7..9..0..m...m..... ..W...i.n..g...a...r.e..a............................8..0..d...m...²... ..F...l.y.i.n...g..-.w...e..i.g..h..t.............5..0..0..0..-..6..0..0..0..g... ..C.....G........f.r.o..m...h..a..n.d...t.o..b..a..c..k..4..3..0..-.4..4.0..m...m.... RECOMMENDED CONFIGURATION ..M...o...t.o..r................................6..S....4..2..5..5... ...E..S...C..........................................8..0..A.... ..S...e..r.v..o........................................1..8..g.... ..P..r..o..p..e..l.l.e..r...............................1..4..*.8..F.... ..B...a..t.t.e..r..y.....................6..S...1..6..0...0..0..m...a..h... ..R...C............................................4..C...H.... x8 01 Glue and close the fuselageTimber boarding everywhere,attention the mounting direction of the board on the winglet. 02 Cut out the pre-reserved slot on the aileron by a new blad.Lay out the wires,Glued foam,bend the ailerons ,and put the tape on the ailerons. 03 Fix the motor, and cement it to the fuselage in advance, you can also first fix the layer board base, and afterwards install the motor. 04 use the tube as a guide, align and glue it.After gluing, you can butt the wing to make a trial of the accuracy, insert the extending into the fuselage through the line slot. 05 Put on the Velcro,Finish the installation. 06 C.G. C.G.from hand to back 430-440mmCorel PDF Engine Version 22.1.1.523 CorelDRAW 2020