Introduction
This instruction manual provides essential information for the proper installation, maintenance, and care of your Piegricdiat replacement filters. These filters are designed to maintain the performance of your INSE K370 or N370 cordless vacuum cleaner.
Produit terminéview et compatibilité
The Piegricdiat replacement filter kit includes high-quality HEPA filters designed for specific INSE cordless vacuum cleaner models. These filters are crucial for trapping fine dust and allergens, ensuring efficient cleaning and maintaining air quality.
Important: These replacement accessories are specifically designed for and compatible with the following models:
- INSE K370 Cordless Vacuum Cleaner
- Aspirateur sans fil INSE N370
Please verify your vacuum cleaner model before installation to ensure proper fit and function. These filters are pas universel.
Image: A set of nine Piegricdiat replacement filters. Each filter is circular with a white filter medium and a black plastic frame, featuring a small red tab for easy handling.
Instructions d'installation
Follow these steps to replace the filter in your INSE K370 or N370 cordless vacuum cleaner. No special tools are required for this process.
- Éteindre: Avant de commencer, assurez-vous que votre aspirateur est éteint et débranché de toute source de charge.
- Localiser le compartiment du filtre : Identify the filter compartment on your INSE K370/N370 vacuum. Refer to your vacuum's original manual if you are unsure of its location.
- Supprimer l'ancien filtre : Carefully open the filter compartment. Grasp the old filter, typically by a tab or edge, and pull it out. Dispose of the old filter responsibly.
- Insérer un nouveau filtre : Take a new Piegricdiat replacement filter. Ensure the filter is oriented correctly (usually, it will only fit one way). Gently push the new filter into the compartment until it is securely seated.
- Fermer le compartiment : Refermez fermement le couvercle du compartiment du filtre.
- Test: Turn on your vacuum cleaner to ensure it operates correctly with the new filter installed.
Image: An illustrative diagram showing two Piegricdiat filters and an arrow pointing towards an INSE K370/N370 cordless vacuum cleaner, indicating the filters are compatible and for installation into the vacuum.
Entretien et soins
Regular maintenance of your vacuum filters is essential for optimal performance and longevity of your vacuum cleaner. These filters are designed to be washable and reusable.
- Nettoyage: Periodically remove the filter from the vacuum. Tap it gently over a waste bin to dislodge loose dust and debris. For a more thorough cleaning, rinse the filter under cool, running water until the water runs clear.
- Séchage: Allow the filter to air dry completely for at least 24 hours before reinserting it into the vacuum. Do not use heat to dry the filter, as this can damage the filter material.
- Fréquence de remplacement : For best performance, it is recommended to replace the filters every 3 months, depending on usage frequency and the amount of debris collected. Consistent replacement helps maintain strong suction and efficient filtration.
Image : Un gros plan view of a single Piegricdiat replacement filter, highlighting its washable and reusable nature. The filter has a white pleated surface and a black plastic rim with a red pull tab.
Dépannage
If you experience issues with your vacuum cleaner after installing new filters, consider the following common solutions:
- Aspiration réduite :
- Ensure the filter is clean and completely dry. A wet or heavily clogged filter can restrict airflow.
- Vérifiez que le filtre est correctement positionné dans son compartiment.
- Check for blockages in the vacuum's hose or brush roll.
- Bruits inhabituels :
- Confirm the filter compartment is securely closed.
- Ensure the filter is properly installed and not loose.
If problems persist, consult your INSE K370/N370 vacuum cleaner's original user manual or contact the vacuum cleaner manufacturer for further assistance.
Spécifications du produit
| Fonctionnalité | Détail |
|---|---|
| Marque | Piégricdiat |
| Numéro de modèle | N370-F |
| Appareils compatibles | INSE K370, INSE N370 Cordless Vacuum Cleaners |
| Matériel | Paper, Plastic (HEPA Filter) |
| Poids unitaire (par filtre) | Environ 0.03 lb (15.4 g) |
| Dimensions du produit (par filtre) | 2.72" L x 0.47" W x 2.72" H (69mm x 12mm x 69mm) |
| Réutilisabilité | Réutilisable (lavable) |
| Remplacement recommandé | Tous les 3 mois |
Image : Une image détaillée view of a single Piegricdiat filter with measurements indicating its dimensions: 0.47 inches (12mm) in height and 2.72 inches (69mm) in diameter, with a weight of 0.03lb (15.4g).
Garantie et assistance
For questions regarding the Piegricdiat replacement filters, please refer to the seller's contact information on the purchase platform. For issues related to your INSE K370/N370 vacuum cleaner, please consult the vacuum cleaner's manufacturer for warranty and support details.