Bousnic Replacement Remote for P-Collar 650 Instruction Manual

Introduction

This manual provides essential instructions for the proper use and maintenance of your Bousnic Replacement Remote for the P-Collar 650. Please read this guide thoroughly before operating the device to ensure correct functionality and to maximize its lifespan.

Setup: Pairing the Remote with the Receiver Collar

To ensure your Bousnic P-Collar 650 Replacement Remote functions correctly, it must be paired with the corresponding receiver collar. Follow these steps carefully:

1. Use the channel switch on the remote to select channel 1.
2. With the remote turned on and the receiver collar turned désactivé, press and hold the ON/OFF Button on the receiver collar for approximately 4-5 seconds.
3. The Red and Green LED lights on the receiver collar will blink for about 10 seconds, indicating that the receiver is in pairing mode.
4. While the receiver's LEDs are blinking, press and hold both the Bouton de tonalité et le Bouton de vibration on the remote at the same time for approximately 2-3 seconds. The Green LED on the receiver collar will blink 5 times, confirming successful pairing.

Utilisation de la télécommande

Once paired, the remote allows you to control the P-Collar 650 receiver. Refer to the original P-Collar 650 manual for detailed instructions on using the various functions (e.g., tone, vibration, static stimulation) and their appropriate application in dog training. Ensure the remote is charged and within operational range of the receiver collar.

Entretien

• Nettoyage: Essuyez la télécommande avec un chiffon doux et sec. Évitez d'utiliser des produits chimiques agressifs ou des nettoyants abrasifs.
• Batterie: The remote uses a Lithium Ion battery (included). Recharge as needed using the provided charging cable. Do not attempt to replace the battery yourself.
• Stockage: Store the remote in a dry, cool place away from direct sunlight and extreme temperatures when not in use.

Dépannage

• La télécommande ne répond pas : Ensure the remote is charged and turned on. Verify that it is within range of the receiver collar.
• Échec du couplage : If the remote fails to pair, ensure the receiver collar is completely turned off before initiating the pairing sequence. Repeat the pairing steps carefully. Check that the remote is also turned on during the pairing process.
• Fonctionnement intermittent : Check for obstructions between the remote and the receiver. Ensure both devices are adequately charged.

Caractéristiques

Garantie et assistance

For warranty information or technical support regarding your Bousnic Replacement Remote for P-Collar 650, please refer to the documentation included with your original P-Collar 650 system or contact Bousnic customer service directly. Contact details can typically be found on the manufacturer's official website ou sur l'emballage du produit.