Introduction
This manual provides detailed instructions for the setup, operation, and maintenance of your TFA Dostmann SKY Radio Weather Station 35.1152.01. This device offers accurate indoor and outdoor temperature and humidity measurements, a weather forecast display, and a radio-controlled clock with an alarm function. Please read these instructions carefully before using the device to ensure proper function and longevity.
Image : Avant view of the TFA Dostmann SKY Radio Weather Station 35.1152.01, displaying forecast, outdoor temperature and humidity, indoor temperature and humidity, and time/date.
Contenu du colis
Please check that all components are present and undamaged after unpacking:
- 1x Base Station (Display Unit)
- 1x Thermo-Hygro Transmitter (Outdoor Sensor)
- 1x Manuel d'instructions
Note: Batteries are not included. You will need 3x AAA batteries for the base station and 2x AAA batteries for the outdoor sensor.
Installation
- Insérez les piles :
- Ouvrez le compartiment à piles à l'arrière de l'appareil. capteur extérieur. Insert 2x AAA batteries, observing the correct polarity (+/-). Close the compartment.
- Ouvrez le compartiment à piles à l'arrière de l'appareil. station de base. Insert 3x AAA batteries, observing the correct polarity (+/-). Close the compartment.
The device will power on and begin searching for the outdoor sensor signal and the radio time signal.
Image : Arrière view of the base station, showing the battery compartment and various control buttons.
- Sensor Synchronization: The base station will automatically attempt to connect with the outdoor sensor. This may take a few minutes. Once connected, the outdoor temperature and humidity will appear on the display. If the connection is not established, press the RECHERCHE button on the base station to initiate a manual search.
Image: The remote outdoor sensor, displaying its own temperature and humidity readings and indicating 433 MHz transmission.
- Radio Clock Synchronization: The base station will automatically attempt to receive the DCF radio time signal. This process can take several hours, especially during initial setup. Ensure the station is placed away from sources of interference (e.g., TVs, computers).
- Placement of Outdoor Sensor:
- Place the outdoor sensor in a shaded, dry location, protected from direct sunlight and precipitation, to ensure accurate readings.
- The maximum transmission range between the sensor and base station is approximately 60 meters (197 feet) in open areas. Walls and other obstacles will reduce this range.
Mode d'emploi
Afficher plusview
The display is divided into several sections, providing comprehensive weather and time information:
- PRÉVISION: Displays weather symbols for current and next day's forecast.
- DE PLEIN AIR: Shows current outdoor temperature and humidity, along with daily high (HI) and low (LO) records.
- INTÉRIEUR: Displays current indoor temperature and humidity, and a comfort zone indicator.
- HEURE DATE: Heure, date et jour de la semaine radiocommandés.
Image: A detailed diagram highlighting various display sections and their functions, including dimensions of the base station.
Boutons et fonctions
| Bouton | Fonction |
|---|---|
| MODE / RÉGLAGE | Press to cycle through display modes or hold to enter setting mode. |
| ALARME ON / OFF | Active ou désactive l'alarme. |
| ° C / ° F | Permet de basculer l'affichage de la température entre Celsius et Fahrenheit. |
| VAGUE | Manually initiates radio time signal reception. |
| RECHERCHE | Manually initiates outdoor sensor signal reception. |
| MÉTÉO | Adjusts weather forecast settings (if applicable). |
| ALERTE | Sets temperature alerts. |
| MÉMOIRE | Displays maximum and minimum recorded values. Press again to clear. |
| SNOOZE / LUMIERE | Activates snooze function during alarm or temporarily illuminates the backlight. |
Prévisions météorologiques
The weather station predicts weather trends for the next 12-24 hours based on changes in atmospheric pressure. The forecast is represented by symbols (e.g., sun, clouds, rain). The accuracy is approximately 70% after a learning phase of several days.
A frost symbol may appear when outdoor temperatures are between -2°C and +3°C, indicating potential for icy conditions.
Valeurs Max/Min
The station automatically records the highest and lowest indoor/outdoor temperatures and humidity values daily. These values are reset automatically every 24 hours. You can also manually reset them using the MÉMOIRE bouton.
Comfort Zone Indicator
The indoor section of the display includes a comfort zone indicator, which provides a visual representation of the indoor climate based on temperature and humidity levels.
Entretien
- Nettoyage: Nettoyez l'appareil avec un chiffon doux et sec.amp chiffon. N'utilisez pas de nettoyants abrasifs ou de solvants.
- Remplacement de la batterie : Replace batteries in both the base station and outdoor sensor when the low battery indicator appears on the display. Always replace all batteries at the same time.
- Stockage: Si vous devez stocker l'appareil pendant une période prolongée, retirez toutes les piles afin d'éviter les fuites.
Dépannage
| Problème | Cause possible | Solution |
|---|---|---|
| No outdoor temperature/humidity reading (--- displayed) |
|
|
| Incorrect time or time not setting automatically |
|
|
| Prévisions météorologiques inexactes |
|
|
| L’affichage est sombre ou vide |
|
|
Caractéristiques
| Fonctionnalité | Détail |
|---|---|
| Numéro de modèle | 35.1152.01 |
| Dimensions (Base Station) | 12.3 x 5.2 x 11.7 cm (L x l x H) |
| Weight (Base Station) | 217 gramme |
| Source d'alimentation (station de base) | 3 piles AAA (non incluses) |
| Source d'alimentation (capteur extérieur) | 2 piles AAA (non incluses) |
| Plage de température extérieure | -20 ° C à +50 ° C (-4 ° F à +122 ° F) |
| Plage de température intérieure | -10 ° C à +50 ° C (+14 ° F à +122 ° F) |
| Taux d'humidité | 20 % - 99 % HR |
| Précision de la température | ±1 °C |
| Fréquence de transmission | 433 MHz |
| Portée de transmission maximale | Compteurs 60 (zone ouverte) |
| Matériel | Plastique (Kunststoff) |
| Type d'affichage | Numérique |
| Caractéristiques spéciales | Alarm, Weather Forecast, Radio Clock, Max/Min Memory, Comfort Zone |
Garantie et assistance
TFA Dostmann products are manufactured to high-quality standards. While specific warranty details are not provided in this manual, spare parts availability is indicated for 1 year from the date of purchase within the EU.
For technical support, warranty claims, or further assistance, please contact your retailer or the manufacturer directly. Manufacturer information can often be found on the product packaging or their official website.
Fabricant: TFA Dostmann
Website: www.tfa-dostmann.de