FOXX A1 Smart Phone User Manual

Do not use it while recharging.
Do not use hand-held while driving.
This device may produce a bright or ﬂash light.
For body-worn operation, maintain aspiration of 5 mm.
Do not dispose of the phone in a ﬁre.
Small parts may cause a choking hazard.
Avoid contact with magnetic media.
This device may produce a loud sound.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Avoid extreme temperatures.
Keep away from pacemakers and other personal medical devices
Avoid any contact with liquid. Keep it dry.
Switch off when instructed in hospitals and medical facilities.
Do not attempt to disassemble your phone.
Switch off when instructed in aircraft and airports.
Do not rely on this device for emergency communications.
Switch off in explosive environments.
Only use approved accessories.

What aisin the Box
The phone packaging box should contain the following items and accessories: Phone, Charger, USB Type-C cable, Protective ﬁlm (applied), SIM card tool, Quand ick Start Guide.

Notices for the Use of Your Phone
Your phone should be treated with care. The following suggestions can help you extend the life of your mobile phone.

Place the mobile phone and its parts and components out of reach of young children.
Keep the phone dry. Rain, humidity, and all types of liquid that contain minerals will corrode electronic circuits.
Don’t touch the phone with wet hands when charging, it will cause an electric shock or damage the phone. Avoid placing the device in high-temperature environments. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.
Avoid placing the device in a lolow-temperaturenvironment. When the temperature rises, the phone will produce water vapor that may damage electronic circuits.
Avoid placing the phone in dusty, dirty places, otherwise parts may be damaged.
Avoid placing the phone near a lit cigarette, open ﬂame, or any heat source.
Do not drop, knock,k, or shake the phone. Rough handling can damage internal circuit boards.
Do not paint the phone. The paint may block headphones, microphones, s or other removable parts, and cause them not to work.
Use a clean, soft, dry cloth to clean the camera, and light sensor lenses. Prohibit the use of harmful chemicals and cleaning agents to clean the phone.
Pacemaker manufacturers recommend that a minimum separation of 5mm be maintained between a mobile phone and a pacemaker to avoid potential interference with the pacemaker (when the device is
used in the USA, the separation distance can be maintained at 10mm between the user’s body and handset). To achieve this use the phone on the opposite ear to your pacemaker and do not carry it in a breast pocket.
Please consult your doctor and the device manufacturer to determine if the eoperationof your phone may interfere with the operation of your medical device.
Turn off your mobile phone or wireless devices when in a blasting area or areas posted turn off “two-way radios” or “electronic devices” to avoid interfering with blasting operations.
There is a risk of explosion if the battery is replaced with an incorrect type. Dispose of used batteries according to the instructions.

Getting to Know Your Phone

Power Key

Press and hold to Power on/off, or Restart the phone.
Press to wake up or turn off the display.

Home Key

Touch to return to the home screen.
Touch and hold to open Google Assistant.

Menu Key

Touch to see recently used applications.

Back key

Touch to go back to the previous screen.

Volume Keys

Press or hold to turn the volume up or down.

Before Getting Started

Removing the Back Cover

Installing SIM Cards

Installing a microSD Card (Not Included)

NOTE:

Some applications may require a microSD card to work normally or may store certain data on it. Therefore, it is recommended that you keep a microSD card installed and not remove or replace it randomly

Installing the Battery

Closing the Back Cover

Basic Settings

Your service provider may default some device settings, so you may not be able to change these settings.

Display

Brightness

Brightness level: Adjust the screen brightness.

Lock display

Lock screen: Customized what to show on the lock screen.
Screen timeout: Adjust the time allowed before the screen goes to sleep after inactively.

Appearance

Dark theme: turn on/off the dark background.
Font size: Set the font size of the system.
Display size: Set the display size of the screen.

Other display controls

Auto-rotated screen: Swipe to turn on or off.
Screen saver: Choose the screen saver and when to start. System

Languages and input

You can set up all the languages supported by the phone.
Keyboards: You can set up an on-screen keyboard or a physical keyboard.

Date and time

Set time automatically: Swipe right to use the date and time provided by the network.
Time zone: You can choose to use the time zone provided by the network or use the location to set the time zone.
Time format: You can choose to use the local default time format or to use the 24-hour format.

About phone

Here you can check out the basic information: device name, phone numbers, legal information, and device details including SIM status, memory/storage information, operation system, IP address,uptimee, build number, etc.

Technical Specifications

Network
- 2G: 850/900/1800/1900
- 3G: B2/4/5
- 4G: B2/4/5/7/12/13/17/25/28AB/41/66/71
Display: 6.0″
Memory: 2GB RAM+32GB ROM
Camera: 5MP+2MP
FM / MP3 / MP4 / GPS/ G-sensor
Battery Capacity: 3000mAh Li-ion

(*): The storage capacity available in the unit’s internal

SAR Information Statement

The SAR limit of USA (FCC) is 1.6W/kg averaged over one gram of tissue. Device types: smartphone (FCC ID: 2AQRM-A1) has also been tested against this SAR limit. The highest SAR value for this mobile phone tested is 0.72W/kg against the head and 1.07W/kg at 10mm from the body. Memoryy may be less due to the preloaded operating system and/ or other pre-installed or configured applications. Check the spacy available on your computer.

FCC Declaration of Conformity

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Use the smartphone in an environment with a temperature between -10°C~+45°C/ +14°F~+113°F. Use the earphones carefully. Excessive sound pressure from earphones and headphones can cause hearing loss. The product shall only be connected to a USB interface of version USB2..0

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Manufacturer: Foxx Development Inc. 3480 Preston Ridge Road, Suite 500, Alpharetta, GA 30005

Information for auxiliary equipment

Battery

Model A1
Capacity 11.21Wh
Manufacturer Ningbo Veken Battery Co., Ltd
Address of Manufacturer No2, Area 0212, West Zone Free Trade Zone, Ningbo, Zhejiang, Province, P.R. China

WEEE Recycling

This product should not be treated as household waste, instead, ad it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

GSM

Operation Frequency
- GSM 850
- TX:824-849MHz; RX:869-894MHz GSM 900
- TX:890-915MHz; RX:935-960MHz DCS 1800
- TX:1710-1785 MHz;RX:1805-1880MHz PCS 1900
- TX:1850-1910MHz;RX:1930-1990MHz

WCDMA

Operation Frequency
- Band 2:TX:1850-1910MHz; RX:1930-1990MHz
- Band 4:TX:1710-1755MHz; RX:2110-2155MHz
- Band 5:TX:824-849MHz; RX:869-894MHz

LTE

Operation Frequency
- Band 2:TX:1850-1910MHz; RX:1930-1990MHz
- Band 4:TX:1710-1755MHz; RX:2110-2155MHz
- Band 5:TX:824-849MHz; RX:869-894MHz
- Band 7:TX:2500-2570MHz; RX:2620-2690MHz
- Band 12:TX:698-716MHz; RX:728-746MHz
- Band 13:TX:777-787MHz; RX:746-756MHz
- Band 17:TX:704-716MHz; RX:734-746MHz
- Band 25:TX:1850-1915MHz; RX:1930-1995MHz
- Band 28:TX:703-748MHz; RX:758-803MHz Band 41:TDD:2496-2690MHz
- Band 66:TX:1710-1780MHz; RX:2110-2200MHz
- Band 71:TX:663-698MHz; RX:617-652MHz

Operation Frequency
- 87.5MHz-108MHz

GPS/GLONASS

Operation Frequency
- L1:1559MHz~1610MHz
- R1:1559MHz~1610MHz

Google is a trademark of Google LLC.

FCC Warning

Labeling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Information the to user.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device,undero part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Absorption Rate (SAR) information:

This device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement

The SAR limit of USA (FCC) is 1.6 W/kg averaging over one gram of tissue. This device was tested for typical body-worn operations with the back of the device kept 10mm from the body. To maintain compliance with
FCC RF exposure requirements, use accessories that maintainanaan appropriate separation distance between the user’s body and the back of the device. The use of belt clips, holste,, rs and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requiremens, and should be avoided. Use only the supplied approved antenna.

Documents / Resources

FOXX A1 Smart Phone [pdf] User Manual
2AQRM-A1, 2AQRMA1, A1 Smart Phone, A1, Smart Phone, Phone

References

User Manual

FOXX A1 Smart Phone

Product Safety Information