EXCLUSIVE 
Two-In-One TWS Speaker
PISA

Fontastic 260803 PISA Two In One TWS Speaker

User Manual

Thank you for purchasing the Pisa wireless speaker.
Pisa consists of 2 TWS speaker units that can be placed together or separately, as desired, and will provide perfect surround sound. The exceptionally balanced sound of the Pisa, combined with a deep bass distinguishes the Fantastic speaker. Have fun using your Fontastic Pisa speaker.
Please read the user manual carefully and follow the safety instructions.
Package contents:

  • Speaker Pisa
  • Dual Micro-USB charging cable
  • Instruction manual

Overview:
Fontastic 260803 PISA Two In One TWS Speaker - overview

  1. Microphone
  2. Micro USB port
  3. On/off button / multifunction button
  4. Status LED

Getting started Charging the battery
Both Pisa units are equipped with an internal rechargeable Lithium-Ion battery. Connect the Dual Micro-USB cable, which is included, to the Micro USB charging port of both Pisa units. Connect the USB-A connector to a USB charger. Any standard USB charger can be used, although we recommend chargers with 5V/2A or more than 2A. The speaker’s status LED will glow red during charging. When fully charged, the LED will turn off. The cable can now be disconnected from the speaker and the charger. Fully charge both units before using them for the first time.

Fontastic 260803 PISA Two In One TWS Speaker - chargingNote: A low battery level is indicated by an acoustic signal. Please charge the speakers.
Note: To save power, the speaker will turn off after 10 minutes if there is no connection.
Switching on/off
To turn on the speaker, press and hold the ON/OFF button for about three seconds. The device switches on. The status LED flashes blue, the device is in pairing mode.
To turn off the speaker, press and hold the ON/OFF button for about three seconds. The device and the status LED switch off.
TWS function
Pisa consists of 2 separate speaker units. To enjoy full stereo music streaming, it is recommended to connect both Pisa units together (TWS).
Set up TWS connection The TWS function allows you to connect both Pisa units together. To connect the two units, turn on both Pisa speakers at the same time. The blue LED of both units will start blinking and the units will connect automatically. After both units are connected (approx. 4-6 seconds), a signal will sound and the LED of the TWS speakers will light up permanently.
Pairing with a Bluetooth® source
Pisa must be paired with a Bluetooth device before it can be used. After a successful TWS connection, pairing with a Bluetooth device can take place.

  1.  Activate the Bluetooth® search function in your music source (e.g. smartphone).
  2. The searching Bluetooth® device indicates that it has found the speaker „Pisa”.
  3. Confirm the pairing with „Pisa”. Enter „0000″ if you are asked for a pairing code. A successful connection is indicated by an acoustic signal and the constant glow of the blue LED.
    When using a Bluetooth device without a display, switch it to pairing mode and wait a few seconds for the connection with the speaker to be established.
    Note: If the connection is lost or the transmitter is disconnected for a short time, Pisa will automatically try to reconnect. If the connection cannot be restored after 3 seconds, restart the pairing process.
    Music playback
    Play music via Bluetooth. Start music playback on the Bluetooth® source paired with the Pisa. The music is transmitted to the Pisa speaker. Stop the music playback of the Bluetooths source to interrupt the music streaming.
    Music control
    To play or stop music, briefly press the multifunction button.

Volume adjustment
The volume must be adjusted via the audio source.
Hands-free function
The built-in microphone and intelligent noise cancellation make the speaker suitable to be used as a hands-free speaker for phone calls.
Note: High volume may cause feedback with the microphone. This will cause echo on the phone side, not on the speakerphone side.
Accepting/ending/rejecting calls
To answer an incoming call, briefly press the multifunction button on one of the speakers once. To end an ongoing call, briefly press the multifunction button on one of the speakers once. To reject incoming calls, press the multifunction button twice briefly. To transfer an ongoing call to the smartphone, briefly press the multifunction button twice. Repeat the process to return the call to the speaker.
Separating/assembling loudspeaker units
To separate the units, take the device in both hands and turn the units against each other. To put them back together, proceed in reverse.
Fontastic 260803 PISA Two In One TWS Speaker - loudSafety information:

  • Never open the device.
  • Do not submerge the device in water and keep it away from moisture.
  • Never forcibly connect a cable.
  • Place the device only on flat surfaces.
  • Remove electronic devices from the power supply if they will not be used for a length of time.
  • Do not use the device if it exhibits visible damage.

Technical Specification:

  • BT: 5.0
  • True Wireless Stereo (TWS)
  • Transmission range: 10m
  • Speaker per unit: 53 mm diameter, 10 watts, 40
  • S/N ratio: 70dB
  • Charging voltage: 5V/0.8A
  • Protection class: IPX6 (splash-proof and suitable for outdoor use)
  • Battery capacity: 2 x 1500mAh
  • Internal microphone
  • Operating time: 12-13 hours
  • Charging time: 2-3 hours
  • Total dimensions: 204 x 74.5 x 74.5mm
  • Total weight: 792g ± 10

No liability is accepted for any damage which may occur through the improper operation.
If you require technical support, please contact our support team via email at [email protected].
Registration and Safety Certification/General Information
CE SYMBOLWe hereby declare that this device carries the CE mark in accordance with the regulations and standards. It conforms with the fundamental requirements of the RED 2014/53/EU, as well as the RoHS directive 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: www.d-parts.de/Konfo
Note on environmental protection:
Dustbin IconAfter the implementation of the European Directive 2012/19/EC in the national legal system, the following applies: Electrical and electronic devices may not be disposed of with domestic waste. Consumers are obliged by law to return electrical and electronic devices at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details of this are defined by the national law of the respective country. This symbol on the product, the instruction manual, or the package indicates that a product is subject to these regulations. By recycling, reusing the materials, or other forms of utilizing old devices, you are making an important contribution to protecting our environment.

The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc.
and any use of such marks is under license.
Improvement and changes of the technical specifications and other data’s could
be made without prior notice.
Registered trademarks are the property of their respective owners.
Fontastic, by D-Parts GmbH
Birkenweiher Str. 16 • 63505 Langenselbold, Germany

Documents / Resources

Fontastic 260803 PISA Two-In-One TWS Speaker [pdf] User Manual
260803, PISA Two-In-One TWS Speaker

Leave a comment

Your email address will not be published.