FIXED Float Edge Waterproof Mobile Phone Case Instructions
- Water resistance IPX8
- Touch control of the phone
- High-quality locking system
- Air pocket
- Neck strap
USE
Opening the mechanism
Inserting the phone
Closing the mechanism
IMPORTANT
TEST WATER RESISTANCE BEFORE USE
- Puta piece of paper into the case and immerse the product under water
for at least 30 minutes. - Open the case and check whether the paper is wet. If so, check that the case is properly closed and repeat the test.
- After a successful test, you can start using the case.
- The air in the air pocket around the circumference or the back of the case that ensures its floating evaporates over time.
RECOMMENDATIONS
- Donot store in a humid environment
- Donotuse in water with temperatures above 60 °C / 140 °F
- Donot expose to fire or excessive heat
- Donot interfere with the closing mechanism
- Avoid contact with creams and oils
- Donot insert any organic matter
- Always wash the case and allow it to dry
NOTES
The product is warranted in accordance with the regulations in force in the countries where it is sold. In case of service problems, contact the dealer from which you have purchased the product. FIXED assumes no liability for damage caused by improper use of the product.
Keep the manual.
TROUBLESHOOTING
In case of problems with the product, you can contact our support at
www.fixed.zone/podpora
Documents / Resources
 |
FIXED Float Edge Waterproof Mobile Phone Case [pdf] Instructions Float Edge Waterproof Mobile Phone Case, Waterproof Mobile Phone Case, Mobile Phone Case, Phone Case |
