Firstech FTI-CDP1 Remote Start T Harness
FTI-CDP1 – Vehicle Coverage and Preparation Notes
Firmware:
Covered vehicles use BLADE-AL(DL)-CH8, confirm application, flash module, and update the controller firmware before installing.
CAN:
Type 1 vehicles use CAN connections in harness at OBD-II, the included CAN extension is not required for this install type.
Lighting:
Type B parking lights use the 10-pin connector, please ensure that the unused 6-pin connector is properly secured for safety.
Ignition :
Common ignition provisions are listed in the BLADE diagram, ignition is also available at the vehicle BCM (connector C5/E, pink/white, pin #27)
FTI-CDP1 – Installation and Configuration Notes
- Required CAN connections.
- Not required.
- Vehicle hood status (if required).
- Ignition jumper CONNECT TO PINK, NO CONNECTION required..
- E Ignition connection.
FTI-CDP1 – DL-CH8 – Type 1 2013-17 RAM 3500 TIP Start Diesel
LED Programming Error Codes
- Module LED flashing RED during programming
- 1x – CAN Error, check CAN wiring and voltages
- 2x – Key code not learned, confirm unlock sent, check CAN
- 3x – No immobilizer data, check immo data connection
- 4x – No IGN, check IGN connection
- 5x – VIN not found, check CAN connections
- 6x – No immobilizer data, check immo data connection
- 7x – Not the same key, use only one key for programming
- 8x – No immobilizer data, check immo data connection
- 9x – No immobilizer data 10x – Klon error, redo Klon
MODULE PROGRAMMING PROCEDURE – WITH KLON
- Close driver door. Re-open driver door to wake up data bus.
- Press UNLOCK on OEM remote. If the vehicle is not equipped with an OEM remote, press the module programming button
- Wait, LED will fl ash BLUE once [1x].
- Turn key to ON position.
- Wait, LED will turn solid RED.
- Turn key to OFF position.
- Remove key.
- Insert key into ignition.
- Turn key to ON position.
- Wait, LED will fl ash BLUE.
- Turn key to OFF position.
- WARNING: Disconnect power last. Disconnect RS from vehicle.
- Connect RS to computer and proceed with extended programming.
- WARNING: Do not press RS programming button. Connect power fi rst. Connect RS to vehicle
- Turn key to ON position.
- Wait, LED will turn solid BLUE for 2 seconds.
- Turn key to OFF position
- Turn key to START position.
- Turn key to OFF position
- Module Programming Procedure completed.
WARNING: READ BEFORE REMOTE STARTING THE VEHICLE
IMPORTANT
I All vehicle doors must be closed and locked prior to remote start sequence. Failure to comply will result in remote starter malfunction
TAKE OVER PROCEDURE – TO THE VEHICLE OWNER
NOTE
I All vehicle doors must be closed and locked prior to remote start sequence
TIME RESTRICTI N COMING UP !
- Press UNLOCK on after-market remote.
- TIME RESTRICTION Within 45 SECONDS from previous step: Open vehicle door. Enter vehicle. Close vehicle door. Insert key into ignition. Turn key to ON position. Press and release BRAKE pedal.
- Take over procedure completed.
- Failure to follow procedure within time restriction will result in vehicle engine shutdown
- WWW.IDATALINK.COM
- Automotive Data Solutions Inc. © 2020
Documents / Resources
 | Firstech FTI-CDP1 Remote Start T Harness [pdf] User Guide FTI-CDP1 Remote Start T Harness, FTI-CDP1, Remote Start T Harness, Start T Harness, T Harness |
 | Firstech FTI-CDP1 Remote Start T-Harness [pdf] User Guide FTI-CDP1 Remote Start T-Harness, FTI-CDP1, Remote Start T-Harness, Start T-Harness, T-Harness |
 | Firstech FTI-CDP1 Remote Start T Harness [pdf] User Guide FTI-CDP1 Remote Start T Harness, FTI-CDP1, Remote Start T Harness, Start T Harness, T Harness |
 | Firstech FTI-CDP1 Remote Start T Harness [pdf] Owner's Manual FTI-CDP1 Remote Start T Harness, FTI-CDP1, Remote Start T Harness, Start T Harness, T Harness |
 | Firstech FTI-CDP1 Remote Start T Harness [pdf] User Guide FTI-CDP1 Remote Start T Harness, FTI-CDP1, Remote Start T Harness, Start T Harness, T Harness |
 | Firstech FTI-CDP1 Remote Start T-Harness [pdf] User Guide FTI-CDP1 Remote Start T-Harness, FTI-CDP1, Remote Start T-Harness, Start T-Harness, T-Harness |
 | Firstech FTI-CDP1 Remote Start T-Harness [pdf] User Guide FTI-CDP1 Remote Start T-Harness, FTI-CDP1, Remote Start T-Harness, Start T-Harness, T-Harness |