Honeywell-logoThor VM1A Vehicle Mounted Computer
Käyttöopas 

Ulos laatikosta

Varmista, että lähetyslaatikossa on seuraavat tuotteet:

  • Thor VM1A vehicle-mounted computer (Model VM1A-LON)
  • Regulatory Sheet If you ordered additional accessories for your computer, verify that they are also included with the order. Be sure to keep the original packaging in case you need to return the computer for service.

Tietokoneen ominaisuudet

 

Honeywell Thor VM1A Vehicle Mounted ComputerHoneywell Thor VM1A Vehicle Mounted Computer - Fig

Telakan ominaisuudet

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 1

Vakio telakka

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 2

Enhanced Dock

 

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 3

Kiinnitä ajoneuvoon
The Thor VM1A should be secured to an area in the vehicle where it:

  • Does not obstruct the driver’s vision or safe vehicle operation.
  • Will be protected from rain or inclement weather.
  • Will be protected from extremely high concentrations of dust or wind-blown debris.
  •  Can be easily accessed by a user seated in the driver’s seat while the vehicle is not in operation. To mount the VM1A using a RAM mount system:
  1. Attach RAM base to a vehicle (RAM ball, RAM Clamp, RAM Plate, etc.)
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 4
  2. Attach RAM ball to the Smart Dock
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 5
  3. Attach VM1A assembly to RAM base using RAM arm and tighten knob on RAM arm.

Honeywell Thor VM1A Vehicle Mounted Computer - Fig 6

  • For more mounting details, refer to the user guide available at sps.honeywell.com.
    Virtakaapelin liittäminen 12-48 VDC-ajoneuvoihin (10-60 VDC suora liitäntä)
    Huomautus: Refer to the Thor VM1A User Guide for other power connections, available at sps.honeywell.com.
    Caution: For installation by trained service personnel only.
    Varoitus: Sulakevaatimukset Oikean ja turvallisen asennuksen varmistamiseksi tulokaapeli on kytkettävä ajoneuvon sulakepiiriin. Jos syöttöliitäntä tehdään suoraan akkuun, sulake on asennettava plusjohtoon 5 tuuman sisällä akun positiivisesta (+) navasta. Sulakepiiri vaatii suurimman aikaviiveen (hidas puhallus) sulake, jonka virrankulutus on alla.
  •  Käytä 12 VDC: n tuloa varten 10 A: n hitaasti sulavaa sulaketta, jossa on tasavirtatage rating greater than 12VDC
  • Käytä 24 VDC: n tuloa varten 6 A: n hitaasti sulavaa sulaketta, jossa on tasavirtatage rating greater than 24VDC.
  • Käytä 36 VDC: n tuloa varten 4 A: n hitaasti sulavaa sulaketta, jossa on tasavirtatage rating greater than 36VDC
  • Käytä 48 VDC: n tuloa varten 3 A: n hitaasti sulavaa sulaketta, jossa on tasavirtatage rating greater than 48VDC.
    Huomautus: For North America, a UL Listed fuse must be used.

Virtakaapelin reititysHoneywell Thor VM1A Vehicle Mounted Computer - Fig 7

Virtakaapelin kytkentäkaavio, jossa on kulma ja 6 johtoa
Honeywell Thor VM1A Vehicle Mounted Computer - Fig 8Kierrä punainen ja punainen/valkoinen johto yhteen ja kierrä musta ja musta/valkoinen johto yhteen, ennen kuin liität ajoneuvon sähköverkkoon.
Connect the green wire to the vehicle ground:
Varoitus: For battery-powered vehicles, the green wire must be connected to the vehicle chassis ground.
Varoitus:  For internal combustion engine-powered vehicles, the green wire is connected to the vehicle chassis ground, which can also be battery negative.

Langan väri Yhteys
punainen DC + (10-60 VDC)
Punainen / valkoinen DC + (10-60 VDC)
Musta DC -
Musta / valkoinen DC -
Vihreä Maa
sininen Sytytyksen tunnistus (valinnainen)
Refer to the Thor VM1A User Guide, available at sps.honeywell.comVarten
further information about ignition control.

Ajoneuvon 10-60 VDC: n suora virtaliitäntä

  1. The VM1A must not be mounted in the dock. The power switch on the dock must be turned Off. The power cable must be UNPLUGGED from the dock.
  2. While observing the Fuse Requirements, connect the power cable as close as possible to the actual battery terminals of the vehicle(if using unswitched power).
  3. Use proper electrical and mechanical fastening means for terminating the cable. Properly sized “crimp” type electrical terminals are an accepted method of termination. Select electrical connectors sized for use with 20AWG (0.81mm2) conductors.
  4. Katso johtimien värit ja liitännät seuraavista kytkentäkaavioista:
    • Ignition Control Wiring Diagram If switched vehicle power is available, the ignition wire can be connected. The VM1A will boot up when the vehicle ignition is turned on. Honeywell Thor VM1A Vehicle Mounted Computer - Fig 9• Automaattinen käynnistys- ja käsikäyttöinen kytkentäkaavio Sytytysjohto on jätettävä irti.
    Honeywell Thor VM1A Vehicle Mounted Computer - Fig 10Varoitus: For battery-powered vehicles: Red and red/white wire twisted together to battery positive. Black and black/white wire twisted together to battery negative. The green wire connected to the vehicle chassis ground.
    Varoitus: For internal combustion engine powered vehicles: Red and red/white wire twisted together to battery positive. Black and black/white wire twisted together to battery negative.  The green wire connected to the vehicle chassis ground can also be battery negative
  5. Route the cable the shortest way possible removing any leftover cable, and making sure the cable does not interfere with the safe operation and maintenance of the vehicle. The cable is rated for a maximum temperature of 221°F (105°C). The cable should be protected from surfaces that exceed this temperature, from physical damage from moving parts, and from chemicals or oil that cause the insulation to deteriorate. Avoid sharp bends. The power cable is less flexible in low-temperature environments
  6. Secure the cable to the vehicle structure at approximately one-foot intervals, taking care not to over-tighten, pinch conductors, or penetrate the insulation
  7. Connect the watertight connector end of the power cable to the dock power connector by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely
  8. Secure the power cable to the VM1A using the strain relief cable clamps.
  9. Place VM1A in the dock
  10. If using the Screen Blanking feature, install the screen blanking box or switch. (Refer to the Thor VM1A User Guide, available at sps.honeywell.com, saadaksesi lisätietoja Screen Blanking -ruudusta.)
  11. Press the power switch on the back of the dock
  12. Press the power button on the front of the VM1A
  13. Configure the Auto-ON behavior.

Käynnistä tietokone uudelleen

Saatat joutua käynnistämään tietokoneen uudelleen korjataksesi olosuhteet, joissa sovellus lakkaa vastaamasta järjestelmään tai tietokone näyttää lukitulta.

  1. Pidä virtapainiketta painettuna, kunnes asetusvalikko tulee näkyviin.
  2. Valitse Käynnistä uudelleen.
    Tietokoneen käynnistäminen uudelleen, jos kosketusnäytön näyttö ei vastaa:
    • Paina virtapainiketta ja pidä sitä painettuna noin 8 sekuntia, kunnes tietokone käynnistyy uudelleen.

Huomautus: Lisätietoja lisäasetusten palauttamisesta on käyttöoppaassa.

Tuki

Mene sps.honeywell.com and select Support to search our knowledge base for a solution or to log into the Technical Support portal.
Käyttäjän dokumentaatio
Katso käyttöopas ja muu dokumentaatio osoitteesta sps.honeywell.com.
Rajoitettu takuu
Takuutiedot ovat osoitteessa sps.honeywell.com and select Support > Warranties.
Patentit
Katso patenttitiedot kohdasta www.hsmpats.com.
Tavaramerkit
Android on Google LLC: n tavaramerkki.
Disclaimer
Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made. The information in this publication does not represent a commitment on the part of HII. HII shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. HII disclaims all responsibility for the selection and use of software and/or hardware to achieve intended results. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior written consent of HII. Copyright © 2021 Honeywell International Inc. All rights reserved

Asiakirjat / Resurssit

Honeywell Thor- VM1A Vehicle-Mounted Computer [pdf] Käyttöopas
Thor-VM1A Vehicle-Mounted Computer, Vehicle-Mounted Computer, Mounted Computer

Jätä kommentti

Sähköpostiosoitettasi ei julkaista.