FAT SHARK HDO Plus Dominator HDO Plus OLED FPV Goggles User Guide

Contents hide

Specifications

Dimensions	152.40 mm x 101.60 mm

Follow These Steps

Open the goggles module door and insert the receiver module.
Use a 7-25V (2-6s) power supply to connect the power connector. Long press the power button for 3 seconds to turn on. At this time, the defogging fan will turn on. Long press again to turn off.

After powering on, find the image of the transmitter through the channel selection button.
Fine-tune the focus and IPD until the image is clear and comfortable.

Long press the display 5-way switch to enter the setup menu and adjust the contrast, brightness, and other parameters.
Adjust the headband length and try different shim configurations to find the most comfortable fit.

What is the power requirement for the goggles?
- The goggles require a 7-25V (2-6s) power supply.
How do I adjust the focus and IPD?
- Focus and IPD can be adjusted separately. Slide to adjust IPD and twist to adjust focus.
How do I access the setup menu?
- Long press the display 5-way switch to enter the setup menu.

FOLLOW THESE STEPS

Open the goggles module door and insert the receiver module.
Use 7-25V(2-65) power supply to connect the power connector, long press the power button for 3S to turn on, at this time the defogging fan turn on. Long press again to turn off.

After power on, find the image of the transmitter through the channel selection button.
Fine-tune the focus and IPD until the image is clear and comfortable.

Long press display 5-wayswitch to enter the setup menu and adjust the contrast, brightness and other parameters.
Adjust the headband length, try different shim configurations to find the most comfortable fit.

SCAN FOR FULL MANUAL

FAT SHARK HDO Plus Dominator HDO Plus OLED FPV Goggles [pdf] User Guide
HDO Plus Dominator HDO Plus OLED FPV Goggles, HDO Plus, Dominator HDO Plus OLED FPV Goggles, OLED FPV Goggles, FPV Goggles

Leave a comment