Elite Screens Spectrum 2 Series Remote Control Kit (RC1)

1. محصول تمام شدview

The Elite Screens Spectrum 2 Series Remote Control Kit (RC1), Model ZPM-RT3, provides enhanced control options for your Spectrum 2 Series electric projection screen. This kit includes both Infrared (IR) and Radio Frequency (RF) remote controls, along with a wall box controller, offering versatile operation. It also features a 12V trigger capability for synchronized operation with your projector.

Figure 1: Elite Screens ZPM-RT3 Control System Components

2. محتویات بسته

لطفاً بررسی کنید که تمام موارد ذکر شده در زیر در بسته شما موجود باشد:

• Handheld Infrared (IR) Remote Control (ZRC1-IR)
• Handheld Radio Frequency (RF) Remote Control (ZRC1-RF)
• Wall Box Controller (ZRC1-WB)
• RJ50 Cable (RJ50)
• AAA Batteries (2 required for remotes)
• Circuit Board Housing

Figure 2: Complete ZPM-RT3 Kit Contents

3. راه اندازی و نصب

Follow these steps to install and set up your ZPM-RT3 Remote Control Kit with your Elite Screens Spectrum 2 Series electric screen.

3.1 Connecting the Circuit Board Housing

1. First, unplug your Spectrum 2 Series screen from its power source.
2. Disconnect the 3-Way Control In-Line switch from the Spectrum 2 screen.
3. Connect the Circuit Board Housing to the screen's power input.
4. Plug the Circuit Board Housing into a power source.

3.2 Synchronizing an RF Remote

To ensure your RF remote control communicates with the screen, follow these synchronization steps:

1. Connect the Wallbox Controller to the Circuit Board Housing using the RJ50 cable.
2. On the Wallbox Controller, press and hold the 'Programming Key' (usually a small button on the side or back).
3. While holding the 'Programming Key', press the 'Up Key' on the Wallbox Controller.
4. Immediately press the 'Up Key' on the RF Remote you wish to synchronize.
5. The RF remote is now synchronized and can control your Spectrum 2 screen.

3.3 Setting up Wireless 5-12 Volt Trigger

The 12V trigger feature allows your screen to automatically deploy or retract in sync with your projector's power cycle. A 3.5mm to 3.5mm mono cable is required (not included).

1. Connect one end of the 3.5mm mono trigger cable to the RF Remote.
2. Connect the other end of the cable to the 12V trigger output on your projector.
3. Turn on the projector, and the screen should automatically deploy.
4. Turn off the projector, and the screen should automatically retract.

4. Operating the Remote Control Kit

The ZPM-RT3 kit provides multiple ways to control your screen:

4.1 Handheld Remote Controls (IR & RF)

• دکمه بالا: Press to raise the screen.
• دکمه پایین: Press to lower the screen.
• دکمه توقف: Press to stop the screen at any desired position.

The RF remote offers greater range and does not require direct line-of-sight, while the IR remote requires pointing directly at the screen's IR receiver.

4.2 Wall Box Controller

The wall box controller provides manual control directly on the wall. It features similar Up, Stop, and Down buttons for convenient operation.

Figure 3: Wall Box Controller

4.3 Programmable Vertical Drop Position

The kit allows for user-friendly programmable vertical drop positions. Refer to the detailed instructions provided with your screen or the full installation video for specific programming steps to set your desired screen stop points.

5. تعمیر و نگهداری

The ZPM-RT3 Remote Control Kit requires minimal maintenance. Keep the remotes and wall box controller clean and dry. Avoid exposing them to extreme temperatures or direct sunlight for prolonged periods. Replace AAA batteries in the remotes as needed to ensure optimal performance.

6 عیب یابی

7. مشخصات

• شماره مدل: ZPM-RT3
• ابعاد محصول: 8 x 2 x 12 اینچ
• وزن مورد: 2 پوند
• باتری ها: 2 AAA batteries required (for remotes)
• نوع کنترل: Infrared (IR), Radio Frequency (RF), Manual Wall Box
• ویژگی خاص: Pre Programmed, 12V Trigger compatible
• دستگاه های سازگار: Elite Screens Spectrum 2 Series electric projector screens

8. گارانتی و پشتیبانی

Elite Screens provides a 2-year warranty for this product. For technical support, product inquiries, or warranty claims, please contact Elite Screens customer service. Elite Screens offers U.S. based stock, service, and lifetime tech support.

Figure 4: Elite Screens Customer Support Information

You can find more information and contact details on the official Elite Screens webسایت یا از طریق مستندات محصول شما.