Okin 2 Button 5 Pin Recliner Hand Control with USB - Instruction Manual

مقدمه

This manual provides instructions for the installation, operation, and maintenance of your Okin 2 Button 5 Pin Lift Chair or Power Recliner Hand Control with USB.

This control unit is designed for use with compatible lift chairs and power recliners, offering convenient control over reclining functions and a built-in USB charging port.

ویژگی های محصول

• مواد: Zinc alloy pane for durability.
• شارژ USB: 5V 2A output for mobile devices.
• طول کابل: Approximately 125cm (4.1Ft) recliner switch cable.
• سازگاری: Works with Okin, Ashley Furniture, Dewert, Flexteel, Limoss, and many other power recliners using a 5-pin connection.

Okin 2 Button 5 Pin Recliner Hand Control with USB, showing the two control buttons and the USB charging port.

راه اندازی و نصب

This section details the steps for replacing or installing the hand control unit.

ابزار مورد نیاز: Small flat-head screwdriver or putty knife (for prying), zip ties (optional, for cable management).

مراحل نصب:

1. قطع برق: Ensure the recliner is unplugged from the electrical outlet before beginning installation.
2. حذف کنترل قدیمی: Carefully remove the existing hand control unit from its mounting location. This may involve gently prying it out of the armrest or side panel.
3. کابل را جدا کنید: Disconnect the 5-pin connector of the old control from the recliner's motor or control box.
4. اتصال کنترل جدید: Connect the new Okin 2 Button 5 Pin Hand Control's cable to the recliner's control box. Ensure the 5-pin connector is securely seated.
5. کابل مسیر: Route the cable neatly and secure it with zip ties if necessary to prevent snagging or damage.
6. واحد نصب: Insert the new hand control unit into the mounting hole. Ensure it clicks into place or is securely fastened using the provided circlips.
7. برق را دوباره وصل کنید: Reconnect the recliner to the electrical outlet.

منفجر شد view diagram illustrating the components of the recliner hand control and its installation into a wooden frame, showing the switch cover, lower cover, circlips, and studs.

Close-up of the 5-pin connector, which connects the hand control to the recliner's motor system.

دستورالعمل های عملیاتی

The Okin 2 Button 5 Pin Hand Control provides simple operation for your power recliner.

عملکرد خوابیده:

• Extend Footrest / Recline: را فشار داده و نگه دارید "UP" button to extend the footrest and recline the chair.
• Retract Footrest / Upright: را فشار داده و نگه دارید "DOWN" button to retract the footrest and return the chair to its upright position.
• توجه: Some recliner models may require continuous pressure on the button for the full range of motion.

پورت شارژ USB:

• The integrated USB port (5V 2A) is designed for charging mobile devices. Connect your device's USB cable to the port.
• Ensure the recliner is connected to a power source for the USB port to function.

تعمیر و نگهداری

To ensure the longevity and proper function of your hand control unit:

• تمیز کردن: Keep the unit clean by wiping it with a soft, dry cloth. Avoid abrasive cleaners or solvents, which can damage the surface or internal components.
• بازرسی کابل: Ensure cables are not pinched, twisted, or damaged. Regularly inspect the cable for any signs of wear, fraying, or cuts.
• شرایط محیطی: Do not expose the unit to excessive moisture, direct sunlight, or extreme temperatures.

عیب یابی

واحد کنترل پاسخ نمی دهد:

1. بررسی برق: Verify that the recliner is properly plugged into a working power outlet.
2. بررسی اتصال: Ensure that all cable connections, especially the 5-pin connector to the recliner's motor, are secure and fully inserted.
3. آسیب کابل: Inspect the control cable for any visible damage or cuts. A damaged cable may prevent proper function.
4. Motor/Power Supply: If the issue persists after checking connections and cable, the recliner's motor or power supply unit may need inspection by a qualified technician.

پورت USB شارژ نمی شود:

1. Recliner Power: Ensure the recliner is powered on and connected to an electrical outlet. The USB port requires power from the recliner's system.
2. Cable/Device Check: Try a different USB cable or device to rule out issues with the charging cable or the device being charged.
3. جایگزینی واحد: If the USB port still does not function, the control unit may require replacement.

مشخصات

Detailed dimensions of the Okin 2 Button 5 Pin Recliner Hand Control, showing measurements of 3.27 inches, 1.42 inches, and 3.9 inches.

عقب view of the control unit, displaying product identification labels including P/N JLDK-17, DC 24V 2A, USB 5V 2A, and manufacturer Okin Refined Electric Technology Co., Ltd.

گارانتی و پشتیبانی

For warranty information or technical support regarding this Okin 2 Button 5 Pin Recliner Hand Control, please refer to the documentation provided with your original recliner or contact the manufacturer directly. Specific warranty terms for this replacement part may vary.