CRC 32080-AA GALVACOLOR Double-Action Anti-Corrosion Paint User Manual

مقدمه

The CRC 32080-AA GALVACOLOR is a double-action anti-corrosion paint designed for effective protection of metal surfaces. This product provides both active corrosion protection and a durable decorative finish in RAL 7035 Light Grey. It is suitable for various applications requiring robust rust prevention and a professional appearance.

اطلاعات ایمنی

هشدار: This product is highly flammable and contains propellants. Read all safety instructions on the can before use.

• در محلی با تهویه مناسب استفاده شود. از استنشاق بخارات آن خودداری کنید.
• از تجهیزات حفاظت فردی مناسب، از جمله دستکش و محافظ چشم استفاده کنید.
• دور از گرما، سطوح داغ، جرقه، شعله باز و سایر منابع اشتعال نگهداری شود. سیگار کشیدن ممنوع.
• حتی پس از استفاده از سوراخ و سوزاندن آن خودداری کنید.
• دور از دسترس کودکان نگهداری شود.
• محتویات/ظروف را مطابق با مقررات محلی دور بریزید.

راه اندازی

آماده سازی سطح

• Ensure the surface is clean, dry, and free from dust, grease, oil, and loose rust.
• For optimal adhesion and corrosion protection, lightly sand smooth surfaces.
• Remove any existing loose paint or rust with a wire brush or sandpaper.
• Mask off areas not intended for painting.

Can Preparation

• Shake the can vigorously for at least 2 minutes after the mixing ball begins to rattle. This ensures proper mixing of pigments and binders.
• Test spray on an inconspicuous area or scrap material to check color and spray pattern.

Operating (Application)

1. Hold the can upright approximately 20-30 cm (8-12 inches) from the surface.
2. Apply the paint in thin, even coats using a steady, sweeping motion.
3. Avoid applying thick coats to prevent drips and runs.
4. Allow each coat to dry for 5-10 minutes before applying the next. Multiple thin coats provide a more durable and even finish than one thick coat.
5. For best results, apply 2-3 coats.
6. After use, invert the can and spray until only clear propellant comes out. This cleans the nozzle and prevents clogging for future use.

زمان خشک شدن: Touch dry in approximately 15-20 minutes. Fully dry in 24 hours. Curing time may vary depending on temperature and humidity.

تعمیر و نگهداری

تمیز کردن

• Clean the spray nozzle after each use by inverting the can and spraying until clear propellant is emitted.
• If the nozzle becomes clogged, remove it and clean it with a thin wire or solvent. Do not use sharp objects that could damage the nozzle.

ذخیره سازی

• Store the can in a cool, dry, well-ventilated place, away from direct sunlight and temperatures above 50°C (122°F).
• Ensure the cap is securely replaced after use to prevent accidental discharge or drying of the nozzle.

عیب یابی

• الگوی اسپری ناهموار:

  Ensure the can is shaken thoroughly before and during use. Check if the nozzle is clean and not partially blocked. Maintain a consistent distance from the surface.

• Drips or Runs:

  This usually occurs from applying too much paint in one coat or holding the can too close to the surface. Apply thinner, multiple coats.

• گرفتگی نازل:

  Clean the nozzle immediately after use by inverting the can and spraying until clear. If already clogged, remove and clean with a solvent or thin wire.
• چسبندگی ضعیف:

  Ensure the surface was properly cleaned and prepared, free from grease, oil, or loose particles. Sanding smooth surfaces can improve adhesion.

مشخصات

گارانتی و پشتیبانی

برای اطلاعات خاص گارانتی یا پشتیبانی فنی، لطفاً به وب‌سایت رسمی سازنده مراجعه کنید. website or contact CRC customer service directly. Keep your purchase receipt as proof of purchase.

سازنده: CRC

تصویر محصول

Image: A 500ml aerosol can of CRC GALVACOLOR double-action anti-corrosion paint in light grey (RAL 7035). The can features the CRC logo and product details, indicating its use for rust protection and a durable finish.