LFI Lights Combo Red Exit Sign with Emergency Lights User Manual

1. مقدمه

This manual provides detailed instructions for the installation, operation, and maintenance of the LFI Lights Combo Red Exit Sign with Emergency Lights, Model COMBO2-R-W-BB. This unit is designed to provide clear exit indication and emergency illumination during power outages, ensuring compliance with safety regulations.

اطلاعات مهم ایمنی

WARNING: Read all instructions carefully before installation. Failure to do so may result in electric shock, fire, or other hazards that could cause injury or death.

• این محصول باید مطابق با کد نصب قابل اجرا توسط شخصی آشنا به ساخت و عملکرد محصول و خطرات ناشی از آن نصب شود.
• Ensure the main power supply is disconnected before installation or servicing.
• This unit is UL 924 Listed, and complies with NEC, OSHA, and NFPA 101 Life Safety Code standards.
• نزدیک بخاری های گازی یا برقی نصب نکنید.
• Do not allow power supply cords to be subjected to undue stress.
• The unit is designed for damp locations but should not be exposed to direct water spray or submersion.

Figure 1: LFI Lights Combo Red Exit Sign with Emergency Lights, showing the red "EXIT" sign and two adjustable LED emergency light heads.

2. راه اندازی و نصب

This unit is designed for hardwired installation and comes with a universal mounting plate for various mounting options (ceiling, wall, end). Ensure all local and national electrical codes are followed during installation.

2.1 نصب

1. قطع برق: قبل از شروع نصب، منبع تغذیه اصلی را از طریق قطع کننده مدار خاموش کنید.
2. انتخاب محل نصب: Choose a suitable location that provides clear visibility for the exit sign and adequate illumination from the emergency lights.
3. Prepare Housing: Remove the faceplate and diffuser from the unit. The housing is injection-molded, 5VA flame retardant thermoplastic.
4. نصب صفحه: Secure the universal mounting plate to the junction box or mounting surface using appropriate hardware (not included).
5. اتصالات سیمی: Connect the unit's wires to the building's electrical supply (120/277 VAC operation).
   • Connect the black wire to 120V AC supply.
   • Connect the red wire to 277V AC supply.
   • سیم سفید را به سیم خنثی وصل کنید.
   • Cap off any unused wires.

Figure 2: Internal wiring and battery compartment. Ensure proper wire connections and battery installation.

2.2 اتصال باتری

The unit includes a long-lasting NiCad battery. Connect the battery pack to the circuit board. Ensure the connection is secure. The battery is designed for low maintenance and provides backup power during outages

2.3 مونتاژ نهایی

1. Knock-out Arrows: If required, use the knock-out arrows on the faceplate to indicate the direction of exit.
2. صفحه جلویی را دوباره وصل کنید: Securely reattach the faceplate and diffuser to the housing.
3. بازیابی برق: Once installation is complete and all connections are secure, restore power to the unit at the circuit breaker.

3. دستورالعمل های عملیاتی

3.1 Initial Operation and Charging

Upon initial power-up, the unit will begin charging its battery. Allow at least 24 hours for the battery to fully charge before conducting the first test. The AC indicator light (usually green) will illuminate when AC power is present and the battery is charging.

Figure 3: AC indicator light and test button. The green light indicates AC power is present.

3.2 Testing the Unit

Regular testing is crucial to ensure the unit functions correctly during a power outage.

1. آزمون ماهانه: Press and hold the "TEST" button for approximately 30 seconds. The emergency lights should illuminate, and the exit sign should remain lit (if applicable). Release the button; the lights should turn off, and the AC indicator should re-illuminate.
2. آزمون سالانه: Disconnect AC power to the unit for a minimum of 90 minutes. The emergency lights and exit sign should remain illuminated for the entire duration. Reconnect AC power; the unit should return to normal operation and begin recharging.

3.3 Adjusting Emergency Light Heads

The two square emergency light heads are adjustable, allowing for optimal light direction. They can rotate 360 degrees and pivot 180 degrees to direct light where needed most.

Figure 4: Illustration of the adjustable emergency light heads, demonstrating their full range of motion.

4. تعمیر و نگهداری

The LFI Lights Combo Exit Sign is designed for low maintenance. However, periodic checks are recommended to ensure optimal performance.

• تمیز کردن: Clean the exterior of the unit and light heads periodically with a soft, damp پارچه از پاک کننده ها یا حلال های ساینده استفاده نکنید.
• باتری: The NiCad battery is long-lasting. If the unit fails the monthly or annual test, the battery may need replacement. Contact a qualified electrician for battery replacement.
• بازرسی: به صورت دوره‌ای دستگاه را از نظر هرگونه آسیب قابل مشاهده، شل شدن اتصالات یا علائم فرسودگی بررسی کنید.

5 عیب یابی

برای مشکلات رایج و راه‌حل‌های آنها به جدول زیر مراجعه کنید.

6. مشخصات

• شماره مدل: COMBO2-R-W-BB (FBA_COMBOR2)
• برند: صنایع نورپردازی
• حجم ورودیtage: 120 / 277 VAC
• نوع نور: All LED (Exit Sign and Emergency Heads)
• نوع باتری: NiCad (Nickel-Cadmium), 1 Product Specific battery required (included)
• مواد مسکن: Injection molded, 5VA flame retardant thermoplastic
• رنگ: مسکن سفید
• ابعاد: تقریباً 20 x 2 x 8 اینچ (50.8 x 5.08 x 20.32 سانتی‌متر)
• Product Dimensions (L x W): 19.22 سانتی‌متر طول × 8.13 سانتی‌متر عرض
• وزن مورد: 2 پوند (0.91 کیلوگرم)
• نوع نصب: Universal (Ceiling Mount, Wall Mount, End Mount)
• رعایت: UL 924 Listed, NEC, OSHA, NFPA 101 Life Safety Code
• حفاظت: اتصال کوتاه، جلدtage surge, brown out, and low battery voltage disconnect protected.
• رتبه بندی مکان: Damp مکان فهرست شده است

7. گارانتی و پشتیبانی

7.1 سیاست بازگشت

This product is subject to a 30-day refund/replacement return policy from the date of purchase. Please refer to your retailer's specific return guidelines for detailed information.

7.2 پشتیبانی فنی

For technical assistance, troubleshooting beyond this manual, or warranty inquiries, please contact Light Fixture Industries directly. Refer to the contact information provided with your purchase or visit the official Light Fixture Industries webسایت برای جزئیات پشتیبانی

سازنده: صنایع نورپردازی

فروشنده: Light Fixture Industries (via Amazon Fulfillment)

برای اطلاعات بیشتر، می‌توانید از سایت Light Fixture Industries Store on Amazon.