1. مقدمه
This manual provides instructions for the safe installation, operation, and maintenance of the Leviton 8200-LW 15-Amp, 125-Volt, Hospital Grade Duplex Receptacle. Please read these instructions thoroughly before beginning installation and retain them for future reference.
تصویر 1: جلو view of the Leviton 8200-LW Hospital Grade Duplex Receptacle in White.
2. اطلاعات ایمنی مهم
هشدار: برای جلوگیری از آتش سوزی، شوک، یا مرگ؛ برق را در مدار شکن یا فیوز خاموش کنید و قبل از سیم کشی تست کنید که برق قطع است!
- Installation must be performed by a qualified electrician in accordance with all national and local electrical codes and regulations.
- Always disconnect power at the main service panel before working with electrical wiring.
- Use only copper or copper-clad wire. Do not use aluminum wire with this device.
- مطمئن شوید که تمام اتصالات سیمی محکم و عایقبندی مناسبی دارند.
- این دستگاه فقط برای استفاده در محیط داخلی طراحی شده است.
- از مقادیر الکتریکی مشخص شده برای دستگاه تجاوز نکنید.
3. محتویات بسته
The package for the Leviton 8200-LW Duplex Receptacle typically includes:
- One (1) Leviton 8200-LW 15-Amp, 125-Volt, Hospital Grade Duplex Receptacle (White)
4. مشخصات محصول
| شماره مدل: | 8200-LW |
| Ampخشم: | 15 Amps |
| جلدtage: | 125 ولت |
| پیکربندی: | 5-15R |
| سیم کشی: | 3-Wire, Self-Grounding (Back and Side Wiring) |
| قطب ها: | 2-Pole |
| مواد: | Nylon (Body/Face) |
| رنگ: | سفید |
| تاییدیه ها: | UL, CSA C22.2, NOM 057 |
| نوع: | Heavy Duty, Hospital Grade |
5. راه اندازی و نصب
ابزار مورد نیاز: Screwdriver (Phillips and/or Flathead), Wire Strippers, Electrical Tape, Voltagتستر.
- خاموش کردن برق: Locate the circuit breaker or fuse that controls the outlet you are replacing or installing. Turn off the power and verify it is off using a voltagتستر الکترونیکی
- پریز قدیمی را بردارید (در صورت وجود): Unscrew the wall plate and then the mounting screws holding the old receptacle in the electrical box. Carefully pull the old receptacle out of the box.
- سیمها را جدا کنید: Note the position of each wire before disconnecting. Typically:
- سیم مسی سبز یا لخت: سیم زمین.
- سیم سفید: سیم خنثی
- Black or Red Wire: Hot (live) wire.
- سیمها را آماده کنید: If necessary, strip approximately 1/2 inch (12.7 mm) of insulation from the ends of the wires. Ensure the wire ends are clean and straight.
- Connect Wires to New Receptacle: The Leviton 8200-LW supports both back and side wiring.
- سیم اتصال به زمین (مس سبز یا لخت): Connect to the green hexagonal ground screw.
- Neutral Wire (White): Connect to the silver terminal screws.
- Hot Wire (Black or Red): Connect to the brass terminal screws.
For Side Wiring: Loop the wire clockwise around the screw terminal and tighten securely. Ensure no bare wire is exposed outside the terminal.
For Back Wiring: Insert the stripped wire end into the appropriate hole on the back of the receptacle and tighten the corresponding screw on the side. The V-shaped, serrated back-wiring clamps ensure superior contact.
- ظرف ایمن: Carefully fold the wires into the electrical box. Insert the new receptacle into the box and secure it with the mounting screws.
- نصب صفحه دیواری: Attach the wall plate over the receptacle.
- بازیابی برق: Turn the power back on at the circuit breaker or fuse.
- تست: Test the receptacle with a known working device.
6. دستورالعمل های عملیاتی
The Leviton 8200-LW Duplex Receptacle functions as a standard electrical outlet. Once properly installed and powered, simply insert the plug of your electrical device into one of the two available outlets. Ensure the plug is fully inserted for a secure connection.
7. تعمیر و نگهداری
- تمیز کردن: To clean the receptacle, ensure power is off at the circuit breaker. Wipe the surface with a soft, damp پارچه از پاک کننده ها یا حلال های ساینده استفاده نکنید.
- بازرسی: Periodically inspect the receptacle for any signs of damage, such as cracks, discoloration, or loose connections. If any damage is observed, disconnect power and have the device inspected or replaced by a qualified electrician.
- "Green Dot" Marking: This hospital-grade receptacle features a permanent "Green Dot" marking on its face, indicating its compliance with hospital-grade standards for enhanced durability and reliability.
8 عیب یابی
| مشکل | علت احتمالی | راه حل |
|---|---|---|
| در پریز برق وجود ندارد | Circuit breaker tripped or fuse blown. Loose wiring connection. | Check and reset the circuit breaker or replace the fuse. Turn off power and check all wire connections for tightness. |
| Plug feels loose in the receptacle. | Worn receptacle contacts (unlikely for new hospital-grade). Incorrect plug type. | Ensure the plug is fully inserted. If the issue persists with multiple devices, consult a qualified electrician for inspection. |
| Receptacle is hot to the touch. | Overload on the circuit. Loose connection. Faulty device. | Immediately disconnect power. Reduce the load on the circuit. Have a qualified electrician inspect the wiring and device. |
9. گارانتی و پشتیبانی
Leviton products are manufactured to the highest quality standards. For specific warranty information and customer support, please refer to the documentation included with your purchase or visit the official Leviton webرسید خرید خود را به عنوان مدرک خرید نگه دارید.
پشتیبانی مشتریان لویتون:
- از پشتیبانی Leviton دیدن کنید Webسایت
- Refer to the contact information provided on the product packaging.