EVOLUTION POWERSPORTS - logo300DU0170 Spark Arrestor
Instruction Manual
SKU(s): (2.5”) 300DU0169, (3.0”) 300DU0170

INCLUDED PARTS
(1) EVP Spark Arrestor

REQUIRED TOOLS
5mm Allen Wrench

Step 1: Make sure the vehicle is cold and in the park.
Step 2: You will find the spark arrester on the exhaust exit, remove the 5mm Allen.
Step 3: Place the new spark arrestor into the exhaust and tighten the 5mm Allen.

For Defender Spark Arrestor

Step 1: Make sure the vehicle is cold and in the park.
Step 2: Open the utility box.
Step 3: Remove the (3) bolts holding the exhaust tip on. Remove the exhaust tip and gasket.
Step 4: Inside the exhaust tip, you will find the spark arrestor. Replace the spark arrestor.
Step 5: Install the gasket and (3) bolts mounting the tip to the muffler.
Step 6: Close the utility box.

NOTE: After installing your new muffler, run the vehicle for at least 10 minutes without the spark arrestor screen installed. This is to make sure that any loose fibers that are left inside the muffler during the manufacturing process are cleared out of the system. Please re-install after this clean-out period.
Reminder: It may not be legal to drive your side by side in certain areas without a spark arrestor. It is the customer’s responsibility to see what their local laws and regulations are.

WE’D LOVE TO HEAR FROM YOU –
LEAVE A REVIEW 8 STAY CONNECTED!EVOLUTION POWERSPORTS - icon 1

Documents / Resources

EVOLUTION POWERSPORTS 300DU0170 Spark Arrestor [pdf] Instruction Manual
300DU0170, Spark Arrestor, 300DU0170 Spark Arrestor, Arrestor

Leave a comment

Your email address will not be published. Required fields are marked *