EVO80 Wireless Keyboard
Accessory List
- Spare Switches / USB-C Cable / 2.4GHz Dongle / Keycap & Switch Puller
- Spare Screws (M2.5*3 & M2*4) / Leaf Spring Gaskets
- Mac Add-on Kit / Gaskets / Silicone Dampeners
Easy Disassembly
Press the keycaps with your thumbs and lift the upper part of the top case with your index fingers to release the top ball-catch mechanism
Do the same to the lower part to fully remove the top case
Under the top case, there is a storage slot for the 24GHz dongle.
The dongle should be placed with the housing facing upwards.
Align the top and bottom case, then press the top case down until the ball-catch mechanism engages to install the top case back.
Keyboard Shortcut Reference
*In Mac mode, the F row works as function keys by default, so there’s no need to press the Fn key together.
Backlight and LED Strip Control
Power Management
EV080 is equipped with two 4000mAh batteries. The battery switch is located under the Caps Lock keycap.
Note that this switch is for battery control only and does not change connectivity methods.
Press and hold FN+D to check the battery status:
- When the keyboard is charging, the indicator under the Esc key will turn white and flash rapidly.
- When the keyboard is fully charged, the indicator will turn green and stay on.
- When the keyboard is not charging, the light under the Esc key indicates the battery level with colors: 0%-10% is red; 10%-50% is yellow; 50%-80% is blue; and 80%-100% is green.
Connectivity Method & Pairing
Wired Mode
- Connect the keyboard to your PC using the included USB-C cable,
- Tap FN+ ~` to switch the keyboard to wired mode, The indicator under ~` will stay on for 2 seconds, then return to the normal lighting effect, indicating the connection is established. The device name is EV080,
Note: When the USB-C cable is disconnected, the ~` key indicator will flash slowly for 8 seconds before the keyboard enters sleep mode,
2.4G Mode
- Make sure the keyboard is either connected to a power source or that the battery switch is turned to the ON position.
- Tap FN+4 to switch the keyboard to 2.40 mode. If it’s never paired before, the indicator under 4 will flash rapidly, indicating the keyboard is ready to pain
- Plug the 2.4C dongle into your PC The indicator under 4 will stay on for 2 seconds, then return to the normal lighting effect, indicating the connection is established. The device name is EV080 2.4G.
- If you want to connect to a new device, press and hold FN+4 for 3 seconds to enter pairing mode again.
Note: The white indicator flashes quickly during pairing and slowly when reconnecting.
If pairing isn’t successful within 60 seconds or reconnection fails within 20 seconds, the keyboard will revert to sleep mode.
Bluetooth Mode
- Make sure the keyboard is either connected to a power source or that the battery switch is turned to the ON position
- Tap FN+I / FN+2 / FN+3 to switch the keyboard to the Bluetooth mode. If it’s never paired before, the indicator under the respective key will flash rapidly, indicating the keyboard is ready to pair.
- Once paired, the indicator under the respective key will stay on for 2 seconds before returning to the normal lighting effect, indicating the connection is established. The device name will be EV080 BTI , EV080 BT2, or EV080 BT3, depending on the selected device number.
- If you want to connect to a new device, press and hold FN+I / FN+2 / FN+3 for 3 seconds to enter pairing mode again.
Note: The white indicator flashes quickly during pairing and slowly when reconnecting.
If pairing isn’t successful within 60 seconds or reconnection fails within 20 seconds, the keyboard will revert to sleep mode,
Sleep Mode
The Ev080 is designed for energy efficiency, operating exclusively in wireless modes. Upon establishing a connection, the device enters a low-power sleep mode after three minutes of inactivity During this initial stage, the keyboard’s LEDs are deactivated, but a single key press will promptly awaken the keyboard, which will then be recognized by the connected device. In the event of a disconnection—such as when a PC is powered off or if the wireless dongle is removed—the Ev080 will initiate a search for the paired device. Should it fail to reconnect after 20 seconds of unsuccessful attempts, the Ev080 will transition into a deep sleep mode. In this state, the LEDs remain off, and key presses will not trigger any device response until the keyboard is reconnected or re-paired.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation,
NOTE 1:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 1 5 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2:Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Warranty Registration Card
- Order Number
- Problem Description
- Date
- Shipping Address
Documents / Resources
 | EVO EVO80 Wireless Keyboard [pdf] User Manual 2BPXU-EVO80, 2BPXUEVO80, EVO80 Wireless Keyboard, EVO80, Wireless Keyboard, Keyboard |