INSTRUCTIONS FOR MCMURDO FAST FIND 220

These instructions guide you through fitting your McMurdo Fast Find 220 device into an Atlas lifejacket. Follow each step carefully to ensure safe and correct function. Handle the lifejacket and all device components with care to avoid damage during installation. Many users carry the PLB in a jacket or snug pocket, but a tether is always recommended to prevent loss at sea. Refer to Fig. 8 for guidance on securing the device to your lifejacket after activation.

Before You Begin

Ensure you are familiar with how your Personal Locator Beacon (PLB) works. If unsure, consult your Original Equipment Manufacturer's (OEM) manual. You will need a flat surface to work on and approximately 50 cm of 1 mm braided cord.

Step 1: Attach the Cord

Thread the cord from the device's carrying case through the float case and then to the device. Use bowline knots to secure the connection (see Fig. 1a). Ensure the cord is at least 46 cm (18.25 inches) in length (see Fig. 1b). Note: The cord may not be included with your device; check before beginning.

Fig. 1a: Bowline knot tying process (3 stages).

Fig. 1b: McMurdo Fast Find 220 PLB connected via cord (min 46 cm) to float case and yellow carrying case.

Step 2: Pack the Device

Place the device securely into its carrying and float cases as shown (see Fig. 2).

Fig. 2: McMurdo Fast Find 220 PLB being inserted into yellow carrying case, then into grey float case. Arrows show insertion.

Step 3: Locate the Back Webbing Adjuster

Find the back webbing adjuster on your lifejacket. It will be located on the side opposite the inflator (see Fig. 3).

Fig. 3: Lifejacket views. Left: PLB attached. Right: Arrow points to back webbing adjuster opposite inflator.

Step 4: Unthread the Waist Belt

Unthread the waist belt from the adjuster as shown (see Fig. 4).

Fig. 4: Close-up of unthreading waist belt from adjuster. Arrows show belt path.

Step 5: Thread the Waist Belt

Pass the waist belt through the slot on the device's carrying case, as shown (see Fig. 5).

Fig. 5: Waist belt threaded through slot on PLB carrying case. Arrow shows direction.

Step 6: Secure the Waist Belt

Re-thread the webbing through the back waist adjuster (see Fig. 6).

Fig. 6: Waist belt re-threaded through back webbing adjuster. Arrows show correct path.

Step 7: Final Check and Label

Your lifejacket is now equipped with your PLB. To complete the process, mark the label tucked into the center back panel with "PLB fitted" (see Fig. 7).

Fig. 7: Lifejacket with PLB attached. Inset highlights label on back panel for "PLB fitted" marking. Inset shows settings: Light, Harness, Spray Hood, PLB Fitted, Automatic, Manual, Hydrostatic, 1 YEAR. ℹ️ symbol present.

Step 8: Device Activation

If the device needs to be activated, follow the instructions provided in the OEM (Original Equipment Manufacturer) manual. Once fully activated, tuck the device behind the bladder panel that holds the light (see Fig. 8).

Fig. 8: Two figures showing PLB positioning and final placement behind lifejacket bladder panel.