User Manual for superbrightleds com models including: DS-RT09, DS-RT09 Addressable RGB LED Controller and Remote, Addressable RGB LED Controller and Remote, RGB LED Controller and Remote, LED Controller and Remote, Controller and Remote, Remote
User Manual Important: Read all instructions prior to installation. Addressable RGB LED Controller and Remote DS-SC (with DS-RT09) DS-SC Power Supply Battery Type CR2032 Remote Layout and Functions Addressable RGB Strip L N Safety and Notes · Product should be installed and serviced in accordance with applicable national, state, and local building and electrical codes. · To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures. Battery Safety · Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate. · Even used batteries may cause severe injury or death. · Call a local poison control center for treatment information. · Non-rechargeable batteries are not to be recharged. · Do not force discharge, recharge, disassemble, heat above (manufacturer's specified temperature rating) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns. · Ensure the batteries are installed correctly according to polarity (+ and -). · Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries. · Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations. · Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children. Pairing Remote(s) RGB channel adjustment speed mode brightness Mode Once setup is complete (see page 2) press to cycle between preprogrammed modes. Hold the upper mode (mode plus) button for two seconds to run the mode cycle demo setting. Hold the lower mode (mode minus) button for two ON/OFF seconds to return to and run mode 1. Speed Press to adjust the speed of the selected prepro- grammed mode. Hold the upper speed (speed plus) button for two seconds to select the fastest speed. scene Hold the lower speed (speed minus) button for two seconds to select the slowestspeed. Brightness 1 2 3W white Press to adjust brightness in ten percent increments. Hold for continuous 256 level adjustment. 456 function RGB Press to adjust in ten percent increments. Hold for 78 9 0 continuous 256 level adjustment. White Press to turn white (RGB mix) on/off. Hold for contin- uous 256 level adjustment. Scene 1: red, 2: green, 3: blue, 4: yellow, Each scene button can save one setting. Setting 5: 9: magenta, 6: cyan, 7: orange, light green, 10: natural white 8: purple, is saved by holding scene button for two seconds. Press the scene button after saving settings to recall those settings. REMOTE(S) MUST BE PAIRED AS PART OF THE INSTALLATION PROCESS AND DO NOT COME PRE-PAIRED. EACH CONTROLLER CAN BE PAIRED TO UP TO TEN (10) REMOTES. To pair a remote, press match button on the controller, then immediately press on/off button on the remote. Indicator light on controller will flash slowly while attempting to pair, then five times rapidly to indicate successful pairing. To unpair a remote, hold match button for five seconds. Indicator light on controller will flash five times rapidly to indicate successful unpairing. Rev Date: V2 04/03/2024 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com User Manual Important: Read all instructions prior to installation. Addressable RGB LED Controller and Remote Setting Adjustment DS-SC (with DS-RT09) Strip Length (Pixel Number) Setting Strip length, or pixel number, can be set up to 1,024 pixels. Begin by pressing the function button (*), then entering the number of pixels with the number buttons, then pressing the function (*) button again. Note: Numbers lower than 100 will need a zero (0) entered in before the number. RGB Order RGB order can be set by pressing the function button (*), then entering the one-digit code corresponding with the correct RGB order using with the number pad, then pressing the function (*) button again. Code 1 2 3 4 5 6 RGB Order RGB RBG GRB GBR BRG BGR IC Type Setting IC type can be set by pressing the function button (*), then entering the two-digit code corresponding with the correct IC type using with the number pad, then pressing the function (*) button again. Consult the list below for the code for each IC type. Code 11 12 13 14 15 16 17 18 19 21 22 23 24 25 31 IC Type TM1803 TM1809, TM1804, TM1812, UCS1903, UCS1909, UCS1912, UCS2903, UCS2909, UCS2912, WS2811, WS2812 TM1829 TLS3001, TLS3002 GW6205 MBI6120 TM1814B(RGBW) SK6812(RGBW) UCS8904B(RGBW) LPD6803, LPD1101, D705, UCS6909, UCS6912 LPD8803, LPD8806 WS2801, WS2803 P9813 SK9822 TM1914A Preprogrammed Modes Once remote is paired, hold the upper mode (mode plus) button for 2 seconds to unlock preprogrammed modes which can then be cycled through using the mode buttons on the remote. No. Name No. Name 1 Red Race White Ground 12 Blue White Chase 2 Green Race White Ground 13 Green Cyan Chase 3 Blue Race White Ground 14 RGB Chase 4 Yellow Race Blue Ground 15 7-color Chase 5 Cyan Race Blue Ground 16 Blue Meteor 6 Purple Race Blue Ground 17 Purple Meteor 7 7 Color Multi Race 18 White Meteor 8 7 Color Race Close + Open 19 7 Color Meteor 9 7 Color Multi Race Close + Open 20 Red Float 10 7 Color Scan Close + Open 21 Green Float 11 7 Color Multi Scan Close + Open 22 Blue Float No. Name 23 Purple Float 24 RGBW Float 25 Red Yellow Float 26 Green Cyan Float 27 Blue Purple Float 28 Blue White Float 29 6 Color Float 30 6 Color Smooth Sectionally 31 7 Color Jump Sectionally 32 7 Color Strobe Sectionally Rev Date: V2 04/03/2024 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.comAdobe PDF Library 17.0 Adobe InDesign 19.0 (Windows)