User Manual for HWWR models including: K38 Wireless Lavalier Microphone, K38, Wireless Lavalier Microphone, Lavalier Microphone, Microphone
Amazon.com: HWWR Wireless Microphone for iPhone, 2 Pack Lavalier Microphone, Portable Wireless Lavalier Microphone for Recording, Vlog, Live Streaming, YouTube, Facebook, TikTok, Interviews : Musical Instruments
65x71mm Wireless Lavalier Microphone User Manual K38 Product Introduction Thank you for choosing our products. This product is an intelligent wireless microphone, which can provide professional recording output. Plug and play, no app required. For multiple purposes: It can be used in live stream, video vlog shooting, program interview, interview recording, video teaching and other occasions. The wireless lavalier microphone consists of two parts, the microphone transmitter and the receiver (as shown in the figure below) ID diagram Microphone Transmitter Microphone Receiver Air proof net Microphone indicate lamp Microphone charging joggle/monitor headset hole Microphone clip Power ON/OFF key Mobile phone joggle Receive terminal indicate lamp Receive terminal charging joggle Operating Method First step: connect one end of receive terminal into mobile phone joggle. Second step: long time press the power on key of microphone, the indicate lamp flashing red-green lamp, means that power on successfully; the indicate lamp long time lighting green lamp, means connected successfully. Power on key Third step: the receive terminal indicator lamp normally lighting, the mobile phone open the camera, the direct broadcasting video and other APP then can use the microphone receive sound. Indicate red lamp normally lighting Special instruction: the operating method of step as the below: no battery in the receive terminal, needn't charge when direct broadcasting. Directly charge the mobile phone through the joggle of receive terminal under the situation that no enough mobile phone power when direct broadcasting. Indicator Light Description Microphone Transmitter Function/Status Power-on Power-off Power-on but disconnected state Power-on and connected state Mute Unmute Reverb Monitoring Disconnected state Low battery Charging status Operation Press the key for 3 seconds Press the key for 3 seconds Light Status Red light and green light flash alternately The indicator light is off Red light and green light flash alternately Green lightis always on Click the key Green light flash Click the key Green light is always on Double click the key Plug in TypeC Head Automatic shutdown after no connection for more than three minutes Under the power onstate TypeC cable charging Green light comes on after flashing red light The microphone indicator does not change The indicator light is off The red light comes on every ten seconds The red light is always on; The red light is off when fully charged Receiver Function/Status Power-on Power-off Power-on but disconnected state Power-on and connected state Operation Power on when inserting the device Power off when unplugging the device Light Status Indicator light flash The indicator light is off Slow flashing of Indicator light Indicator light is always on Attention: If one drag two microphone occur that one always flashing and not connect, able to make the connected successfully microphone power off, then plug off the receiver, then power on first and not connect the microphone, then press the switch 8s and not release, till quick flashing, then insert the receiver, connected successfully (power on/off needn't too big power). Package list Microphone launch terminal..............................................2 pieces Receive terminal..............................................................1 piece Charging wire...................................................................1 piece User specification.............................................................1 setCorel PDF Engine Version 14.0.0.701 CorelDRAW