1. Introducción
The SHURFLO 4008-101-E65 3.0 Revolution Water Pump is designed for reliable performance in various plumbing systems, particularly in RV and trailer applications. Its unique one-piece diaphragm and internal bypass system contribute to extended operational life and consistent performance. This pump delivers water at a rate of 3 gallons per minute (GPM) and operates at 12 VDC, providing up to 55 PSI of pressure.
Key features include quiet operation, the ability to run dry without damage, and patent-pending Flow Reaction Technology to minimize noise, vibration, and excessive cycling. This manual provides essential information for the proper installation, operation, and maintenance of your SHURFLO Revolution water pump.
Figura 1: SHURFLO 4008-101-E65 3.0 Revolution Water Pump. This image displays the SHURFLO 4008-101-E65 3.0 Revolution Water Pump. The pump features a black plastic housing for the diaphragm and valve assembly, with two threaded ports for water inlet and outlet. The motor, a cylindrical metal component, is attached to the pump housing and includes a white label with product information. The entire unit is mounted on a black base with rubber feet for stability and vibration isolation.
2. Configuración e instalación
The SHURFLO 4008-101-E65 pump is designed for flexible installation and can be mounted in any position. Ensure the mounting surface is stable and secure to minimize vibration.
2.1 Conexiones de fontanería
- Puertos: The pump features ½”-14 NPSM-male ports for water inlet and outlet connections.
- Presión de entrada: The maximum inlet pressure should not exceed 30 PSI (2.1 Bar).
- Autocebante: The pump is self-priming up to 6 feet (1.82 meters).
- Ensure all plumbing connections are tight to prevent leaks.
2.2 Conexiones eléctricas
- Volumentage: The pump operates on 12 VDC.
- Motor: Permanent magnet, intermittent duty.
- Dirige: The pump comes with 16 AWG leads: 16 inches (40 cm) Red (+) and 10 inches (33 cm) Black (-).
- Fusible: Un 10 Amp fuse is recommended for circuit protection.
- Ensure correct polarity when connecting to the power source.
3. Instrucciones de funcionamiento
The SHURFLO Revolution pump is designed for automatic operation based on water demand.
- Caudal: The pump delivers a flow rate of 3.0 GPM (11.4 LPM).
- Control de presión: The pump features an adjustable pressure switch with a built-in check valve. It will shut off at 55 PSI (3.8 BAR) and restart at 25 PSI (1.7 Bar).
- Funcionamiento silencioso: The pump is engineered for quiet performance, reducing noise and vibration during use.
- Capacidad de funcionamiento en seco: The pump can run dry without sustaining damage, offering protection in low-water conditions.
- Temperatura del líquido: The pump can handle liquid temperatures up to 130°F (54°C) maximum.
4. Mantenimiento
Regular maintenance ensures the longevity and optimal performance of your SHURFLO water pump.
- Inspección: Periodically inspect all plumbing connections for leaks and electrical connections for corrosion or damage.
- Limpieza: Ensure the water inlet is free from debris. If an inline strainer is used, clean it regularly.
- Protección térmica: The motor includes thermal overload protection with automatic restart, safeguarding against overheating.
- Winterización: In freezing conditions, ensure the pump and entire water system are properly drained or winterized according to your RV or system manufacturer's guidelines to prevent freeze damage.
5. Solución de problemas
If the pump is not operating as expected, consider the following common troubleshooting steps:
- Sin energía: Revisa los 10 Amp fuse, battery connections, and ensure the 12 VDC power supply is active.
- Pump Runs but No Water: Verify that the water tank has water, all valves are open, and there are no airlocks in the system. Check for clogged inlet strainer.
- Pump Cycles Rapidly: This may indicate a leak in the plumbing system, a faulty check valve, or an improperly adjusted pressure switch. Inspect all connections for drips.
- Low Flow/Pressure: Check for blockages in the inlet or outlet lines, a dirty strainer, or low voltage supply to the pump.
- Ruido excesivo: Ensure the pump is securely mounted and not vibrating against other surfaces. Flexible hoses on the inlet and outlet can help reduce noise transmission.
6. Especificaciones
Especificaciones de la bomba
- Tipo: 4-chambered diaphragm with adjustable pressure switch and bypass
- Puertos: ½”-14 NPSM-male
- Caudal: 3.0 GPM (11.4 LPM)
- Temperatura del líquido: 130 ° C (54 ° F) máx.
- Principal: 6 pies (1.82 M)
- Presión de entrada: 30 PSI (2.1 Bar) max
- Run Dry: Sí
Especificaciones eléctricas
- Motor: 12 VDC permanent magnet, intermittent duty
- Protección: Thermal overload, automatic restart
- Dirige: 16 AWG, 16" (40 cm) Red (+), 10" (33 cm) Black (-)
- Fusible: 10 Amp recomendado
- Control: Adjustable switch with check valve
- Amps (max): 7.5
- Shutoff Pressure: 55 PSI (3.8 BAR)
- Presión de reinicio: 25 PSI (1.7 bares)
Especificaciones generales
- Dimensiones: 4.9" x 8.1" x 4.3" (125 x 206 x 110 mm)
- Peso del artículo: 4.5 libras
- Material: Metal
- Color: Gris
- Válvula de retención incorporada: Sí
7. Información de garantía
SHURFLO warrants its aftermarket Revolution 4008 Series Potable Water Pumps to be free from material and workmanship defects under normal use and service for 2 años from the date of purchase with a valid purchase receipt. If no purchase receipt is available, the warranty period is 2 years from the date of manufacture indicated on the motor nameplate. Pumps installed as original equipment are covered under the warranty provided by the equipment manufacturer.
8. Información del fabricante
SHURFLO is a division of the Flow Technologies Group of Pentair, Inc. (PNR). Founded in 1968, SHURFLO has established itself as a leading supplier of water pumps for the RV, marine, general industrial, and floor care markets. The company maintains full-service sales, service, and distribution centers, including a hub in Cypress, California, and a facility in Elkhart, Indiana.