Ergomotion Ascend Support Rail Installation Guide

Ascend Support Rail

Product Information

Specifications:

  • Parts Included: Assist Rail, Baffle, M8x40 Hex Screw (x3),
    M8x65 Hex Screw (x3), Hex Key
  • Usage: Support rail installation for bed

Product Usage Instructions

Installation:

  1. Align the assist rail with the mounting holes on the left side
    of the bed.
  2. Secure it in place with the M8x65 hex screws. Use the hex key
    to tighten.
  3. Only remove the support rail cover for washing. Replace
    immediately before using to prevent injury.
  4. If installing only one support rail, install the bolster on the
    opposite side to keep the mattress in place and prevent entrapment
    hazards.
  5. Align the baffle with the mounting holes on the opposite side
    of the bed.
  6. Secure it using the M8x40 hex screws. Use the hex key to
    tighten.
  7. Installation is complete.

FAQ

Q: Can I wash the support rail cover?

A: Yes, you can remove the support rail cover for washing.
However, always replace it immediately before using to prevent any
risks of injury.

Q: Is it necessary to install both support rails?

A: If installing only one support rail, make sure to install the
bolster on the opposite side to ensure the mattress stays in place
and prevent entrapment hazards.

“`

Support Rail Installation Guide

A.

B.

Parts List
C.

D.

E.

A) Assist Rail B) Baffle C) M8x40 Hex Screw (x3) D) M8x65 Hex Screw (x3) E) Hex Key

Installation
1 Align the assist rail with the mounting holes on the left side of the bed. Secure it in place with the M8x65 hex screws. Use the hex key to tighten.

Only remove the support rail cover to wash. Replace immediately before using. Using the bed without the support rail cover may increase the risk of serious injury.
2 If only installing one support rail, be sure to install the bolster on the opposite side to keep the mattress in its place and prevent entrapment hazards. To install the support rail, align the baffle with the mounting holes on the opposite side of the bed. Secure it using the M8x40 hex screws. Use the hex key to tighten.

Installation is complete.

Documents / Resources

Ergomotion Ascend Support Rail [pdf] Installation Guide
Ascend Support Rail, Support Rail, Rail

References

Leave a comment

Your email address will not be published. Required fields are marked *