Instruction Manual for DOMUS models including: Dusk MR16 LED Garden Spike Light, Dusk MR16, LED Garden Spike Light, Garden Spike Light, Spike Light
Dusk MR16 LED Garden Spike Light CCT 6w in Bronze or Black - The Lighting Outlet
Domus Lighting | DUSK-SPIKE-MR16 Dusk LED Garden Spike Light
File Info : application/pdf, 2 Pages, 120.98KB
DocumentDocumentDUSK SPIKE MR16 29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia Phone: 02 9554 9600 | Fax: 02 9554 9433 enquiries@domuslighting.com.au | www.domuslighting.com.au Installation Manual Date: December 14, 2023 1:24 PM Specifications Voltage: Power: IP Rating: CRI: Requires: 12V DC Lumen (±5%): 6W Beam Angle: IP65 CCT: 80 Lifespan: 12V DC Constant Voltage LED Driver (Wire in Parallel) Warm White 3000K - 500lm Neutral White 4000K - 550lm White 6500K - 550lm 60° 3000K-4000K-6500K 50,000hrs Save these instructions Warning - To reduce the risk of fire or injury to persons: · Turn power off or unplug the luminaire and allow it to cool before replacing the lamp · Lamp gets hot quickly. Contact only switch/plug when turning on. · Do not touch the hot lens, guard or luminaire housing until it has cooled · Keep Lamp away from combustibles. · Do not touch lamp. Use a soft cloth. Oil from skin may damage lamp. · Do no operate the luminaire fitting with a missing or damaged shield. Important Safety Instructions · For outdoor use only · Make sure the power is turned off before installing or servicing the luminaire. · WARNING: Risk of electrical shock. Install all luminaires 3.05m or more from a pool, spa or fountain. · Position the wire and wire connector so that it is connected within 15.2 cm from a building or structure, a luminaire or fitting. · Not to be buried except for a maximum of 15.2cm to connect to the main low voltage cable. Lamp Installation/Replacement Instructions · Unscrew the shroud from the fixture housing. · Insert the MR16 LED lamp with correct wattage as marked on the fixture label. · Replace shroud and twist shroud in place. Shroud Note: -The lamp must be installed by professional electrician -Ensure the power supply is switched off before fitting this product Glass LED Lamp Sealing Ring Housing -Do not touch the lamp when in use -Keep away from hot steam and corrosive gas 29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia Phone: 02 9554 9600 | Fax: 02 9554 9433 enquiries@domuslighting.com.au | www.domuslighting.com.au Installation Manual Fixture Mounting Instructions · Disconnect transformer from main power supply. · Remove shroud from the fixture housing · Insert MR16 LED Lamp (10W max) into the lamp socket. · Replace shroud and secure with twisting motion · Run lead wire from the fixture through the ground stake mounting hole. · Insert composite ground stake in desired location until flange of stake is flush to grade. · Screw fixture into top of stake and tighten until snug. · Strip the two fixture lead wires and connect them to the main low voltage supply cable lead with silicone filled wire connectors. Shroud Main Supply Cable Housing Adjustable Knuckle Ground Stake Note: -The lamp must be installed by professional electrician -Ensure the power supply is switched off before fitting this product -Do not touch the lamp when in use -Keep away from hot steam and corrosive gas