Hisense FRIDGE-2087 WiFi-Aparato Uzanta Manlibro

FRIDGE-2087 WiFi Device

The user manual of WIFIBluetooth module
1. La produkta priskribo
The user can achieve the terminal equipment connection WIFI net and Bluetooth, through this module This equipment may be operated in all European countries.
2. Interfaco
interfaco
4pin through hole

Pingla difino
Pinglo 1
2

Name VCC_5V
UART0_TX

Function 5V
UART0_TX

Remarks I/O

3

UART0_RX

UART0_RX

I / O

4

GND

GND

Power consumption requirements
The maximum working current is not more than 500mA, the instantaneous maximum current is not more than 700mA; In standby mode, the power supply of the module shall be no less than 0.45W, and the power supply current shall be no less than 1A (DC-DC is recommended).
2. Bazaj parametroj

Feature Description Model Product Name Major Chipset WLAN Standard Max Power

Feature Description MWB414C.2 WiFi 11b/g/n 1T1R and BLE4.2 Model Realtek RTL8720CF IEEE 802.11b/g/n 20dBm

BT Standard WLAN Frequency Range BT Frequency Range Spread Spectrum
Modulation Method Data Transfer Rate
Antenna Reference Interface Supply Voltage Dimensio Operacia Temperaturo Stokada Temperaturo

BLE4.2 for BLE only 2.4GHz~2.4835GHz
2.4GHz~2.4835GHz IEEE 802.11b: DBPSK, DQPSK, CCK for DSSS (Direct Sequence Spread Spectrum) IEEE 802.11g: BPSK, QPSK,16QAM,64QAM for OFDM (Orthogonal Frequency Division Multiplexing) IEEE 802.11n: MCS0~MCS7,OFDM DSSS/DBPSK/DQPSK/16-QAM/ 64-QAM 802.11b:1,2,5.5,11Mbps 802.11g:6,9,12,18,24,36,48,54Mbps 802.11n:MCS0~MCS7,up to72.2Mbps PCB printed ANT 4pin through hole 5V±0.5V 38×20×3.2mm -10°C to 70°C
-20 ° C al 85 ° C

Note Low Temperature Operation When the external temperature is lower than -10°C, the modules have an increased risk of damage and face unpredictable risks. Do not use modules at temperatures lower than -10 °C!

4. La montra metodo de Modelo aprobita kodo
En la fabriko la modelo aproba kodo estas gluita sur la malantaŭa ŝelo en etikedo.
5. CE Statement
EU DECLARATION OF CONFORMITY Hisense declares that the radio equipment type Hisense MWB414S .05 is in compliance with Directive 2014/53/EU.

6. Deklaro de FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID:********
7. Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of FCC RF Rules. This equipment should be installed and operated with minimum distance of 20 in (50cm) between the radiator and your body. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter CAUTION: To comply with the limits of the Class B digital device pursuant to Part 15 of the FCC Rules, this device is compliant with Class B limits. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables may results in interference to radio or reception
ŜANĜO
Por certigi daŭran plenumon, Ajna ŝanĝoj aŭ modifoj ne eksplicite aprobitaj de la donaciinto de ĉi tiu aparato povus nuligi la aŭtoritaton de la uzantoj funkciigi la aparaton.
8. Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 50 cm(8 in )between the radiator and your body NOTE To satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the end product Contains Transmitter module FCC ID: 2A4A3FRIDGE-2087 To satisfy IESD exterior labeling requirements, the following text must be placed on the exterior of the end product ” Contains Transmitter module IC: ******
Ĉi tiu simbolo sur la produkto aŭ sur ĝia pakaĵo indikas, ke ĉi tiu produkto ne devas esti forĵetita kun via hejma rubo. Anstataŭe, estas via respondeco forigi vian ruban ekipaĵon transdonante ĝin al elektita kolektejo por la reciklado de rubaĵoj elektraj kaj elektronikaj ekipaĵoj. La aparta kolekto kaj reciklado de via malŝparo ekipaĵo en la momento de forigo helpos konservi naturajn rimedojn kaj certigi ke ĝi estas recikligita en maniero kiu protektas homan sanon kaj la medion. Por pliaj informoj pri kie vi povas demeti vian ruban ekipaĵon por reciklado, bonvolu kontakti vian lokan urboficejon, vian hejman forĵetservon aŭ la butikon kie vi aĉetis la produkton. La aparato estas limigita al endoma uzo nur kiam funkcias en la frekvenca gamo de 5150 ĝis 5350 MHz.
This equipment should be installed and operated with minimum distance of 20 in (50cm)between the radiator and

yourbody. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter
Fabrikisto: QingdaoHisense Communication Co., Ltd. Adreso: 218 Qianwangang Road, Qingdao Economic & Technological Development Zone, Qingdao, Ĉinio Importistoj: Hisense France SAS Adreso: 9 Rue des 3 Soeurs, 93420 Villepinte, France Hisense Iberia, SLU Adreso: Ronda Auguste kaj Louis Lumiere. 23 Nave 12. Edificio Lumiere – Parque Tecnológico 46980 Paterna (Valencio) – Hispanio Hisense Italia Srl Adreso: Via Montefeltro, 6/A, 20156 MILANO Hisense Sudafriko Adreso: The Estuaries, Building 17 Oxbow Crescent, Century City, Kab-urbo, Sud-Afriko
9. IC-Deklaro
ithe device for operation in the band 5150­5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;Footnote4 ii for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit; iii for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits as appropriate; and iv where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated. This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: “Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’ exploitation est autorisée aux deux conditions suivantes : 1) l’appareil ne doit pas produire de brouillage; 2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. IC ID*********

Dokumentoj/Rimedoj

Hisense FRIDGE-2087 WiFi Device [pdf] Uzanta Manlibro
FRIDGE-2087, FRIDGE2087, 2A4A3FRIDGE-2087, 2A4A3FRIDGE2087, FRIDGE-2087 WiFi Device, WiFi Device

lasu komenton

Via retpoŝta adreso ne estos publikigita.