ENERMAX FAN UCTB8/9/12/14 Installation Guide

a close up of a fan

 

The Package Includes:

  • T.B. Silence Fan x 1
  • Screws x 4
  • Pin to 4 adaptor x 1

Installation

  1. PC Power off at all times during installation.
  2. Please see the right figure for the airflow directions.
  3. Install the fan on the case with the 4 screws.
  4. Connect the 3 pin connector to a specific 3 pin 12V header on the motherboard OR attached the enclosed 3 pin to 4 pin adaptor to your power supply.

diagram 

Detaching fan blades:

Carefully push out the fan blades with your thumbs in the inner area.


graphical user interface

Reattaching the fan blades:

Press the center of the blades towards the frame until it clicks.

  1. Put the blades back into the frame gently.
  2. Turn around the fan and put it onto a table.
  3. Press the center of the frame towards the table until it clicks.

a man holding a gun
a close up of a fan

 

Documents / Resources

ENERMAX FAN UCTB8/9/12/14 [pdf] Installation Guide
FAN, UCTB8, 12, 14

Leave a comment

Your email address will not be published.