Instructions for ANALOG DEVICES models including: MAX86180, MAX86180 Evaluation System, Evaluation System, System

MAX86180 Evaluation System - Evaluates: MAX86180

MAX86180

Analog Devices, Inc.

MAX86180 Evaluation System

23 hours ago — The GUI setup files can be obtained by the procedure described in the Quick Start section. 2. MAXSENSORBLE EVKIT and EVKIT design files are attached at the ...

prieš 11 valandų — The GUI setup files can be obtained by the procedure described in the Quick Start section. 2. MAXSENSORBLE EVKIT and EVKIT design files are attached at the ...

MAX86180EVSYS User Guide: Evaluation System for the MAX86180 (Rev.1)

MAX86180 Datasheet and Product Info | Analog Devices


File Info : application/pdf, 2 Pages, 284.06KB

PDF preview unavailable. Download the PDF instead.

max86180evsys
Evaluates: MAX86180

Click here to ask an associate for production status of specific part numbers.
MAX86180 Evaluation System

General Description
The MAX86180 evaluation system (EV system) allows for the quick evaluation of the MAX86180 optical AFE for applications at various sites on the body, particularly the wrist. The EV sys supports both I2C and SPI compatible interfaces. The EV sys has two optical readout channels that operate simultaneously. The EV sys allows flexible configurations to optimize measurement signal quality at minimal power consumption. The EV sys supports file logging and flash logging, allowing the user to disconnect from the computer for more convenient data capturing sessions, such as overnight or outdoor running.
The EV sys consists of two boards. MAXSENSORBLE_ EVKIT_B is the main data acquisition board while MAX86180_OSB_EVKIT_B is the sensor daughter board for the MAX86180. To enable PPG measurement capabilities, the sensor board contains seven LEDs (one OSRAM SFH7016, red, green, and IR 3-in-1 LED package, one OSRAM SFH4053 IR LED, one QT-BRIGHTEK QBLP601-IR4 IR LED, one Würth Elektronik INC. W150060BS75000 Blue LED and one QT-BRIGHTEK QBLP595-AG1 green LED) and four discrete photodiodes (VISHAY VEMD8080), and an accelerometer. The EV sys is powered through a LiPo battery attached inside it, and can be charged using a Type-C port. The EV Sys communicates with MAX86180GUI (should be installed in user's system) using Bluetooth® built into Windows® (Win BLE). The EV sys contains the latest firmware but comes with the programming circuit board MAXDAP-TYPE-C in case a firmware upgrade is needed.
Ordering Information appears at end of data sheet.
Visit Web Support to complete the nondisclosure agreement (NDA) required to receive additional product information.

Features
 Quick Evaluation of the MAX86180  Supports Optimization of Configurations  Facilitates Understanding MAX86180 Architecture
and Solution Strategy  Real-Time Monitoring  Data Logging Capabilities  On-Board Accelerometer  Bluetooth® LE  Windows® 10-Compatible GUI Software
EV System Contents
 MAX86180 EV system wrist band, including · MAXSENSORBLE_EVKIT_B board · MAX86180_OSB_EVKIT_B board · Flex cable · 105mAh Li-Po battery LP-401230
 USB-C to USB-A cable  MAXDAP-TYPE-C programmer board  Micro USB-B to USB-A cable

MAX86180 EV System Files

FILE

DESCRIPTION

MAX86180GUISetupV1.0.0_Web.zip

Setup file to install the PC GUI program

MAXSENSORBLE_EVKIT_B.zip

Schematic, BOM, layout

MAX86180_OSB_EVKIT_B.zip

Schematic, BOM, layout

Note:
1. The GUI setup files can be obtained by the procedure described in the Quick Start section
2. MAXSENSORBLE_EVKIT and EVKIT design files are attached at the end of this document.

Windows is a registered trademark and registered service mark of Microsoft Corporation. Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.

319-100948; Rev 1; 3/24

One Analog Way, Wilmington, MA 01887 U.S.A. | Tel: 781.329.4700 | © 2024 Analog Devices, Inc. All rights reserved.

MAX86180 Evaluation System
Notes

Evaluates: MAX86180

Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarks and registered trademarks are the property of their respective owners.

www.analog.com

Analog Devices  40



References

Adobe PDF Library 15.0