EKSELANS 310002 GPON Network Terminal 1 GE Port
Introduction
Description
GPON optical network terminal for SOHO residential and business use. Media converter compatible with market routers.
Key features
- 1 port 10/100/1000BASE-T Ethernet self-adaptive.
- Compatible with ITU-T G.984.x standard, with all requirements for access to FTTH ultra-wideband networks.
- Maximum downstream speed 2.5 Gbps and upstream 1.25 Gbps.
- Local and remote management. OMCI, Web, CLI and SNMP.
- Full compatibility with all of our OLT EK equipment.
Package content.
- 1 x ONT 1
- 1 x power supply 12v.
Interfaces and LEDs
Interfaces
- PON port: We will connect the fiber cable that comes from the installation.
- Ethernet ports: We will connect the end equipment (PC, SWITCH, printers, etc.).
- Power supply: We will connect the 12v power supply.
- Side reset button: Button to perform factory reset. We will press and hold for about 20 seconds to perform a factory reset.
LEDs
- POWER: It will be green when the power supply is correct.
- PON: Blinking green, the fiber part works correctly. Not blinking the ONT is correctly setup.
- LOS: When turned on with red flicker, the PON does not synchronize. It is suggested to check the status of the installation, the cable itself and the connectors.
- LAN: Slight flicker in green means the port is working properly.
FAQ
- We don’t see the equipment on the OLT: Check the status of the PON LED, if it’s not green and the LOST part is flashing, it means the fibber part is wrong.
- We provision the ONT but we cannot navigate when connecting the PC. Verify that the PON and LAN port are turned on otherwise check the OLT configuration.
Documents / Resources
 | EKSELANS 310002 GPON Network Terminal 1 GE Port [pdf] User Manual 310002 GPON Network Terminal 1 GE Port, 310002 GPON Network Terminal 1 GE Port |
