EGLO 204519 Recessed Motion Sensor Instructions
FUNCTION:
- LUX: The LUX knob controls the ambient light level at which the sensor will switch on. At the “sun” position, the sensor will operate 24 hours a day. At the “3” position, the sensor will only operate at night. You can set the sensor to operate at the desired lux level by adjusting the LUX knob.
- TIME: The TIME knob controls how long the light/s will stay on after movement is detected. Once the light has been triggered by the PIR sensor, any subsequent detection will start the timed period again from the beginning.
MANUAL OVERRIDE:
When power is first switched on, the unit will be in AUTO MODE,
SWITCHING TO MANUAL MODE:
- Switching the ON/OFF main switch off & on twice in about 3 seconds, the unit will automatically change into MANUAL MODE.
SWITCHING TO AUTO MODE:
- Switching the ON/OFF main switch off then on after 3 seconds, the sensor will change into AUTO MODE,
- Keep the main switch on, the sensor will switch to AUTO MODE after 8 hours.
080x71mm
220-240 V- 50/60Hz
max.800 W
max.400 W
max.360
max.8 m(<24°C)
2.2-4m
10 sec 15 min
3-2000 Lux
Distributed by:
Reduction Revolution Pty Ltd
www.reductionrevolution.com.au/LED
Documents / Resources
 | EGLO 204519 Recessed Motion Sensor [pdf] Instructions EGLO-Detect-Me-7, 204519, 204519 Recessed Motion Sensor, Recessed Motion Sensor, Motion Sensor, Sensor |
