EEVO MOTORS MS-01 VLCD Display Panel Controls
VLCD Display Panel Instructions
Model: MS-01
Australian Designed | Built to Last
Overview
The MS-01 VLCD display is designed to provide riders with essential ride information and control functions in a compact, user-friendly format. This guide will help you get familiar with its features and operation.
Materials and Dimensions
- Housing Material: Durable plastic
- Operating Temperature: -20°C to 70°C
- Storage Temperature: -30°C to 80°C
Dimensions:
- Width: 90.9 mm
- Length: 160.9 mm
Note: The plastic housing ensures good mechanical performance across these temperatures.
Display Overview
- Speed Information (Real-time, Max, and Average)
- Speed Unit (km/h or mph)
- PAS Level (Pedal Assist Level)
- Battery Power Indicator
- Headlight Indicator
- Startup Indicator
- Walk Assist Icon
- Error Code Indicator
- Trip Information: ODO (Total Distance)
- Single Trip Distance
- Trip Time
Operating Instructions
Power On/Off
- To power on: Long press the MODE button.
- To power off: Long press the MODE button again.
- The display can automatically shut down when the e-bike is not used for more than 10 minutes.
Pedal Assist Levels (PAS)
- You can adjust the pedal assist level using the UP and DOWN buttons.
- Level 0 – No motor support or throttle. The system is active, but motor and throttle are disabled.
- Levels 1–5 – Gradually increase the level of motor assistance.
- Level 1 = minimal assist
- Level 5 = maximum assist
Walk Assist Mode
- Activate: Hold the DOWN button.
- The motor will assist at low speed to help you walk the bike.
- Walk assist mode can only be used when you are pushing the ebike by hand. Please dont use this function when riding.
Headlight Control
- Turn on/off: Long press the UP button for 2 seconds.
- The headlight icon will appear when the light is on. Screen brightness will dim slightly when active.
Changing Display Information
Press the MODE button to cycle through:
- Speed
- Trip Distance
- Odometer (ODO)
- Trip Time
- When viewing the TRIP display, press and hold the DOWN and MODE buttons together to reset the single trip distance to zero.
Battery Indicator
- The battery icon shows real-time charge level.
- If the battery reaches under voltage, a warning will display and needs to be charged immediately.
Error Codes
- If a system error occurs, an error code will appear on the display.
- Do not attempt to repair yourself—please contact Eevo support.
User Reminders
- Do not connect or disconnect the display while the bike is powered on.
- Avoid strong impacts or rough handling.
- Do not alter system parameters unless instructed, as it may affect functionality.
Frequently Asked Questions
How do I reset the single trip distance to zero?
When viewing the TRIP display, press and hold the DOWN and MODE buttons together to reset the single trip distance.
What should I do if an error code appears on the display?
If an error code appears, do not attempt to repair it yourself. Please contact Eevo support for assistance.
Documents / Resources
 | EEVO MOTORS MS-01 VLCD Display Panel Controls [pdf] User Manual MS-01 VLCD Display Panel Controls, MS-01, VLCD Display Panel Controls, Display Panel Controls, Panel Controls |