edishine HCFM02A Ceiling Fan With Light Instruction Manual

To reduce the risk of personal injury, attach the fan directly to the support structure of the building according to these instructions, and use only the hardware supplied.
To avoid possible electrical shock, Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch before installing your fan location. If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.
All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.
To reduce the risk of personal injury, do not bend the blade attachment system when installing, balancing, or cleaning the fan.Never insert foreign objects between rotating fan blades.
To reduce the risk of fire, electrical shock, or motor damage, do not use a solid-state speed control with this fan, Use only our speed controls.

NOTE: The important safety precautions and instructions appearing in the manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense and caution are necessary factors in the installation and operation of this fan.

Parts Inventory

Carefully open the package. Remove items from styrofoam inserts.Remove motor housing and place on carpet or styrofoam to avoid damage to finish.
Check again parts list that all parts have been included.

Hardware Included

Package contents

REMOVE PLASTIC INSERTS

BLADE ASSEMBLING

One blade at a time,Align the blade with the 2 holes in the motor, tighten screws securely.
Repeat for the remaining 2 blades.

LIGHT KIT ASSEMBLING

Remove 3 screws from the motor.

Insert the motor plug into the LED board slot,and then install the light kit to the motor with 3 screws.Align groove in the light cover with ridge in the light kit.
Twist light cover clockwise until it is secure.

REMOVE SCREWS FROM MOUNTING BRACKET

100%(completely) remove 2 screws from the moun?ng plate for later use. 70% remove 2 screws from the moun?ng plate.

MOUNTING PLATE ASSEMBLING

Warning:Failure to disconnect power supply prior to installation may result in serious injury.
For safety and best operating results,recommend you have a qualified electrician install this fan.

Secure mounting plate to outlet box by tightening mounting screws & washers.
The ceiling fan must be installed in a location with a minimum of 300mm
spacing from the tip of the blade to the nearest objects or walls.
Secure the mounting plate to the ceiling joist or structure that is capable of carrying a load of at least 15.9kgs,with two long screws provided.
Ensure at least 30mm of the screws is threaded into the support.

Note: For ease of wiring feed house wires through moun?ng plate.

MAKE ELECTRICAL CONNECTIONS

Hang the hole of the motor cover into the hook of mounting plate.
WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
Make the wire connection between the Fan and power supply.
Make sure all connections are secured.

WHOLE FAN INSTALLATION

Install the cable to the ceiling with screw and washer provided.
Install the whole fan to mounting plate with 4 screws.

SIZE OF PRODUCT

Remote Control Operation

Functional Operation

One Year Limited Warranty

Supported by our professional R&D team and QC team, we provide One Year Warranty for materials and workmanship from the purchase date.
Please note that the warranty does not cover damage caused by personal misuse or improper installation.

Please attach your Order ID and Name so that our dedicated customer service team can help you better.

Read More About This Manual & Download PDF:

Documents / Resources

edishine HCFM02A Ceiling Fan With Light [pdf] Instruction Manual
HCFM02A Ceiling Fan With Light, HCFM02A, Ceiling Fan With Light, With Light

References

User Manual