User Guide
EDF266 2.1 Speaker Systems
This product meets the requirements of the restriction of hazardous substances in electrical and electronic equipment (2011/65/EU Directive and 2015/863 Directive) issued by European Parliament and EU Council on March 31, 2015.
Hereby, Edifier International Limited declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.edifier.com/global/eu-doc
FCC Regulatory Compliance
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
ISED Regulatory compliance
This device contains licence-exempt transmitters that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
| Statement of Compliance – UK PSTI 2023 | ||
| 1. Product type | Product type and model as indicated on the front cover or back cover of the user manual or quick start guide / Batch-All | |
| 2. Name and address of manufacturer | Edifier International Limited P.O. Box 6264 General Post Office, Hong Kong | |
| 3. This declaration of compliance is prepared by the manufacturer of this product. | ||
| 4. To the best of their knowledge, the manufacturer has complied with the deemed compliance conditions in Schedule 2: UK Product Security and Telecommunications Infrastructure Act 2022 UK PSTI Regulations 2023 – Security Requirements for Relevant Connectable Products, Schedule 2 Passwords -There are no default passwords used within the product. Vulnerability Policy -See https://www.edifier.com/uk/policy/security Security Update Period -See https://www.edifier.com/uk/policy/software_update | ||
| 5. References to the relevant standards in relation to which conformity is declared: ETSI EN 303 645 V2.1.1 (issued 2020-06) (provision 5.1-1, 5.1-2, 5.2-1, 5.3-13) | ||
| 6. Defined support period for the product. | 5 Years 2029-12-31 | |
| Signed for and on behalf of the manufacturer: |  | |
| Place and date of issue: | Dongguan 2024-04-28 | |
| Name: | Li Lanqiang | |
| Title: | Certification Center Manager | |
Signature:  | ||
Documents / Resources
 | EDIFIER EDF266 2.1 Speaker Systems [pdf] User Guide Z9G-EDF266, Z9GEDF266, EDF266 2.1 Speaker Systems, EDF266, 2.1 Speaker Systems, Speaker Systems, Systems |