EARTHWAY 2050P Broadcast Spreader with Side Spread Control

EARTHWAY 2050P Broadcast Spreader with Side Spread Control

SIDE SPREAD CONTROL

Patent U.S. 10,993,368 

Your EarthWay spreader includes a patented feature to prevent fertilizer from being spread to the left side. To activate this feature, slide the lever below the hopper to the back (if standing behind the spreader) and position the left wheel 6ʺ-12ʺ from your sidewalk or border. This will not waste fertilizer like competitor designs that leave 7X the fertilizer inside the wheels from blocking material leaving the impeller.

Spreader Setting Chart 

Setting RateLBS/1,000 SQ FTGrams/SQ Meter
111.0 LBS5 GRAMS
132.0 LBS10 GRAMS
143.0 LBS15 GRAMS
164.0 LBS20 GRAMS
175.0 LBS25 GRAMS
186.0 LBS30 GRAMS
197.0 LBS35 GRAMS
208.0 LBS40 GRAMS
229.0 LBS45 GRAMS
2310.0 LBS50 GRAMS

ASSEMBLY: Flip up handle and tighten each wing nut to hold handle in place.

HELPFUL HINTS

Icon Read the directions before assembly.
Icon If your spreader does not spread evenly, be sure “FRONT” on the GEARBOX points to the front of the spreader. The impeller must turn clockwise when pushing forward. Reversing the GEARBOX during assembly will cause issues.
Icon Your spreader is calibrated for three miles per hour, which is a brisk walking speed. Slower or faster speeds will change the spread pattern. Wet fertilizer will also change the spread pattern and flow rate. Do not use powdered materials as it will damage the gearbox.
Icon Gears are permanently lubricated at the factory. Do not open the GEARBOX or dirt may enter.

The settings furnished on the Rate Setting Matrix are intended as a guide only. Variations in physical characteristics of material applied, walking speed, and roughness of ground surface may require slightly different spreader settings. Due to the above conditions, the manufacturer makes no warranty as to the uniformity of coverage actually obtained from the settings listed.

OPERATING INSTRUCTIONS

Icon Obtain proper setting for material to be used from the enclosed SETTING MATRIX included with this spreader, or from our web site under the MANUALS SECTION.
Icon Set stop bolt on rate gauge assembly to the proper rate setting and tighten.
Icon While pushing spreader forward, pull control lever back to stop bolt, to stop spreading, push lever forward to close flow holes before you stop moving.
Icon When finished, empty any remaining material from hopper, rinse spreader, apply coating of light oil to all metal parts. The gearbox is sealed and is factory lubricated.

The Side Spread-Control is a patented innovation that is superior to side deflectors. Side deflectors block material leaving the impeller. This blocked material is now consolidated into a 2-3” wide path on the left inside wheel of your spreader. This equates to wasted fertilizer, dark green stripes, and in some cases this extra fertilizer (seven times) will damage the lawn.
Side Spread-Control maintains the correct application rate while not placing material on driveways, sidewalks, flowerbeds, or worse, the storm drains in your street. This saves you money and keeps you from damaging your lawn.

Symbol

To engage SideSpread-Control:

  1. Locate the lever on under the right side of the hopper.
  2. Slide the control lever from the front to the back.
  3. Position the left wheel of your spreader 6ʺ–12ʺ from the sidewalk, flowerbed, or driveway and spread as normal.
  4. When you have completed this spreading pass, close the control lever to “0”, and then open the Side Spread Control™ by sliding the control lever from back to the front, for a FULL, 180 degree spread pattern.
    Operating Instructions

HOW TO ORDER PARTS

Call or Email: TURF DEPOT 800-305-9255 or earthway@turfdepot.com

How To Order Parts

2050P Broadcast Spreader Parts List
KEYPART #DESCRIPTIONKEYPART #DESCRIPTION
160515CONTROL ASSEMBLY (includes 2,17341031” OD X 17/32” ID X 1/32” WASHER ZINC
212222INDICATOR-BROADCAST1832100¼-20 HEX NUT ZINC
370192.840” X 1.50 x 21” BLACK GRIP1925701REST
460027WING NUT ASSY BLACK2032103¼-20 NYLON INS LOCKBUT ZINC
537108¼-20 x 1 ¾” CARRIAGE BOLT ZINC2112318LOWER HOUSING CLIP
6191327/8” TUBE PLUG2212221SHUT OFF PLATE
731124#10 X 5/8” TYPE A PHPS ZINC2331138#8 X 3/8” PMT #8 HD COARSE BLACK
8331071/8” X 1 ¾” COTTER PIN SS2412248IMPELLER
9331061/8” X 1 ¾” COTTER PIN ZINC2523511AXLE
1060363HOPPER ASSEMBLY (includes 13, 22, & 23)2660404GEARBOX ASSEMBLY
1131161#14 x ¾” TYPE AB HWHS ZINC2712197SPACER BEARING
1233117AGITATOR287010610” PNEUMATIC DRIVE WHEEL
1312209HOPPER BUSHING2960027WING NUT
1460364UPPER HANDLE ASSEMBLYOPTIONAL77003HEAVY DUTY RAIN COVER
1537106¼-20 X 2” CARRIAGE BOLT ZINCOPTIONAL40003DEBRIS SCREEN
1625220LOWER HANDLEOPTIONAL60600SIDE DEFLECTOR

ONE YEAR WARRANTY

Limited Warranty 

EarthWay Products, Inc. provides this limited warranty that this product is free of defects in original workmanship and materials for a period of one year to the end user with the original purchase receipt. If a manufacturing nonconformance is found, EarthWay Products, Inc. at its discretion will repair or replace the part(s)/product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering, improper storage, or normal wear and tear as determined by EarthWay. Due to the corrosive nature of most fertilizers and ice melt products, EarthWay Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or failure due to corrosion or its effects .

EarthWay at its discretion may require that the part(s) or product be returned along with the original purchase receipt for examination and compliance with the terms of this limited warranty. Do not return any product without first receiving authorization from EarthWay Products, Inc. IN NO EVENT SHALL EITHER PARTY BE LIABLE TO THE OTHER FOR SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, EVEN IF SUCH PARTY SHALL HAVE BEEN ADVISED OF THE POSSIBILITY OF THE SAME. To seek remedy under this limited warranty, contact EarthWay Products, Inc. at support@earthway.com or write to EarthWay Products, Inc. 1009 Maple Street, Bristol, IN 46507 and describe the nature of the manufacturing defect. SPECIFIC LIMITATIONS: This limited warranty covers only the part(s) or product; any labor charges associated with repair or replacement of non-conformances are specifically excluded.

The above-listed warranty procedure is a condition precedent to bringing any legal action to enforce this limited warranty. Any action to enforce any portion of this limited warranty must be commenced within ninety days after the expiration of the limited warranty coverage period. Any performance of repairs will not suspend this limitation period from expiring, unless state law provides otherwise. Any performance of repairs after the limited warranty coverage period has expired, or performance of repairs regarding anything excluded from coverage under this limited warranty shall be considered “good will” repairs, and they will not change the express terms of this limited warranty or extend the limited warranty coverage period.

Exclusive jurisdiction for deciding legal disputes relating to alleged breach of warranty or representations of any nature relating to this limited warranty must be filed in the courts of Elkhart County within the State of Indiana. Any and all claims, controversies, and causes of action arising out of or relating to this limited warranty, whether sounding in contract, tort or statute, will be governed by the laws of the State of Indiana, without giving effect to any choice or conflict of law provision or rule.

NO OTHER WARRANTY, EXPRESS, IMPLIED OR STATUTORY, SHALL APPLY, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY, APPLICATION OR FITNESS FOR A PARTICULAR PURPOSE, OR ANY OTHER WARRANTY OBLIGATION ON THE PART EARTHWAY, AND ALL SUCH WARRANTIES ARE EXPRESSLY DISCLAIMED. In the event that applicable law prevents the disclaimer of any implied warranties, then such implied warranty shall be limited to the fullest extent permitted by law. Without limiting the foregoing, if applicable prevents the disclaimer of any such implied warranties, this limited warranty limits the period of time in which a claim for breach of implied warranties, including but not limited to the implied warranty of merchantability or fitness for a particular purpose, may be filed. In such event, any claim for breach of implied warranty must be brought before the expiration of this express limited warranty’s one year term.

CUSTOMER SERVICE

SUPPORT@EARTHWAY.COM | www.EARTHWAY.com | 1009 Maple Street, Bristol, IN 46507

Logo

Documents / Resources

EARTHWAY 2050P Broadcast Spreader with Side Spread Control [pdf] Instruction Manual
2050P Broadcast Spreader with Side Spread Control, 2050P, Broadcast Spreader with Side Spread Control, Spreader with Side Spread Control, Side Spread Control, Spread Control, Control

References

Leave a comment

Your email address will not be published. Required fields are marked *