Eachine Nano V3 VTX

Product Parameters

• Built-in Microphone
• Input voltage: DC 5V
• PIT@75mA
• 25mW@180mA/ 1 6dBm
• 1 00mW@280mA/21 .5dBm
• 200mW@330mA/24.5dBm
• 400mW@400mA/27.5dBm
• Antenna interface: ipex
• Output power: PIT /25/1 00/200/ 400mW
• Standard 40 channels. A/B/E/F/R frequency group
• Installing Hole:
  • 20X20mm.M3
  • 25.5X25.5mm.M2
• Size: 28mm x 1 3.6mm x 5mm
• Weight: 3g

Wiring Diagram

Interface Definition

Function button settings

1. Setting methods for VTX parameters: OSD control through flight controller or VTX button control ;
2. The protocol used for OSD: IRC tramp.
3. The parameter table value for output power “25/1 00/200/ 400MW” is “25/100/200/400”;
   

Power indicator status

Frequency sheet

Button control definitions

1. Long press for 2 seconds, the LED indicator will start switching from channel, band and power repeatly (red for power, blue for channel, green for band)
2. Long press for 2 seconds until the blue indicator is ON for channel setup. Short press to switch channel. When CH1 is selected, the indicator flashes once; when CH2 is selected, the indicator flashes twice, and so on.
3. Long press for 2 seconds until the green indicator is ON for band setup. Short press to switch band (A->B->E->F->R->A repeatly). When Band A is selected, the indicator flashes once; when Band B is selected, the indicator flashes twice, and so on .
4. Long press for 2 seconds until the red indicator is ON for power setup . Short press to switch power (25mw->100mw->200mw->400mw->PIT , 25mw repeatly ). When 25mw is selected, the indicator flashes once; when 1 00mw is selected, the indicator flashes twice, and so on. The red indicator will be solid at Pit mode.
5. When the drone arms, long-press in advance to directly enter PIT mode.

Company: Lotus NL B.V
Address: Koningln Julia~plein 10, le Verd, 2595M, The Hague, Netherlands.
E-mail: peter@lotusnl.com
Tel: +31644168999

Documents / Resources

EACHINE Eachine Nano V3 VTX [pdf] User Manual EACHINE, Nano, V3, VTX

References

• User Manual