P329.01X Liberty TWS Earphones XO-9852 User Manual

USER MANUAL

P329.01X Liberty TWS Earphones
Model: XO-9852

TWS Earphones and Charging Case
Model: XO-9852
FCC ID: 2ALCFXO-9852

What’s include?

  • TWS earbuds with charging case x 1
  • Micro USB charging cable x 1
  • Interchangeable ear tips x 2 pairs

Charging the earbuds:
Put the earbuds into the charging case to charge the earbuds. Make sure the earbuds are securely placed into the case. The LED indicators on earbuds will light up in red when the earbuds are being charged. The LED indicators on earbuds will go out when the earbuds are fully charged.

(When the earbuds are being charged, the LED indicator on charging case will flash in
blue.)

Charging the charging case:
Use the provided micro USB cable to connect to an AC adapter or computer to charge the charging case. The LED indicators on charging case will flash in blue when the charging case is being charged. The LED indicators on charging casestay solid blue when the charging case is fully charged.

How to use?
When the earbuds are in the charging box, just take them out and the 2 earbuds will
power on automatically.
(When the earbuds are not in the charging box, press and hold both power buttons
simultaneously for 2-3 seconds to power on the earbuds.)

When the earbuds are powered on, the LED indicators will alternately flash red and blue. After 2-3 seconds, the LED indicators will flash blue slowly, which means both earbuds are paired with each other successfully.
(If both earbuds do not pair together after 10 seconds, tap the power button on either
earphone to force them to pair.)

Check Bluetooth setting menu on your smart devices and make sure that Bluetooth is
turned ON. Connect with the device listed as “Liberty wireless earbuds”.

FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Questions about your Manual? Post in the comments!

Leave a comment

Your email address will not be published. Required fields are marked *