USER MANUAL

TC01-C1 Dog Training Collar

Dog Training Collar
Model: TC01-C1

Product Overview

Remote Control

Remote Control

Screen

Screen

II. Package Content

Package Content

Receiver

Receiver

III. Setting Up

  1. Charge the devices respectively for 2 hours and above.
Charge the devices

2. Match the Remote Control to the Receiver:
*You may skip this step because the set is already paired by factory setting?

Match the Remote Control

Adding multiple Receivers:

Adding multiple Receivers:

3. Removing all Matched Receivers:

Press and hold Static Level Regulator Activation Button and Beep Button simultaneously for 8 secs. The Channel Display

Removing all Matched Receivers

4. Configurating Static Levels:

Configurating Static Levels:

IV. Training Modes

  1. Vibration Mode:
Vibration Mode:

2. Sound Mode:

Sound Mode:

3. Static Stimulation Mode:

Static Stimulation Mode:

Do not hold the button as it is not recommended to have prolonged shock to your dog. The static, however, will cut off in 4 secs automatically to prevent unintentional harm to your pet.

4. Switching Channel:

Switching Channel:

V. Wearing the Receiver Collar

Wearing the Receiver Collar

VI. Training Tips

  1. Reward your dog with food will usually help to achieve the best result.
  2. Do not use the device on dogs aged below 6-month, old, pregnant, easily frightened, aggressive, in heat, old, and dogs not in best of health.
  3. Use verbal commands first, and supplement with a corrective stimulus only as needed. Be consistent with your verbal commands, using the same words every time. Work with your pet on one behavior at a time to avoid confusion and frustration.
  4. Use verbal commands first, and supplement with a corrective stimulus only as needed. Be consistent with your verbal commands, using the same words every time. Work with your pet on one behavior at a time to avoid confusion and frustration.
  5. For example, use the beeps as warning by pressing Beep Button. The dog will become conditioned to the beep preceding the corrective stimulus and will soon learn to recognize the beep as a warning along with your verbal command.
  6. Do not rely on this product solely to train your dog. Some dogs will not respond to this product. We cannot guarantee the effectiveness of this or any trainer on your dog. If your dog shows signs of growling, snarling, biting or aggression while using the collar, discontinue use immediately and contact a professional trainer for advice.

VII. Important Notice

Regarding you and the product:

  1. It is strictly prohibited to open the Receiver in any situation. Doing so will likely compromise the waterproof function and thus voiding the product warranty.
  2. Please use Remote Control and Receivers from the complete set, do not use other product to match with the Receiver.
  3. If you want to test the product, please use professional testing apparatus. Do not test with hands, so as to avoid accidental injury.
  4. If find water at the charging port, please wipe it dry before charging.
  5. Beware the interference from the environment can cause the product not to work properly. For examples are places with high voltage facilities, communication towers, thunderstorm, large buildings, and strong electromagnetic interference.
  6. Both Remote and Receiver have automatic power-saving mode. They will enter sleep mode if idling for 5 mins
  7. The included collar is a basic accessory and is not necessarily suitable for all types of dog breeds. Any collar not wider than 24mm and not thicker than 5mm, made of soft material, can be a replacement for the current collar.

Regarding well-being of your dog:

  1. The Receiver collar is not a regular collar and not recommended to put on a leash to walk your dog. (Doing so during pulling may hurt the dog due to protruding electrodes on the Receiver.)
  2. Do not put the collar on for over 12 hours, it may cause rashes or discomfort to your dog’s skin.
  3. Do not allow children, or anyone who has little to no experience with training dogs, to handle this training kit.
  4. In order to guarantee normal diving function, please insert the waterproof rubber lid over the charging port.
  5. Static stimulation is not a pleasant experience for any dogs. Punishment is harsh way to train a dog. Always praise and encourage your dog for good behavior. Note: With Anti-Misoperation design, Static function always cut-off after 4 secs, this is a precaution designed to prevent unintentional long-pressed of the button, and potential animal abuse.

VIII. Troubleshooting

  1. Remote/Receiver runs out of power quickly;
    not charging Make sure the charger and Remote/Receiver is securely connected. Try to use other universal android USB cable to charge.
  2. Static is too weak or even completely no static; Static Mode has no effect on my dog.
    Make sure the receiver has enough power(when it is low-battery, shock doesn’t work); Only both electrodes are simultaneously touched by dog’s skin shock will work; Try to increase the static level to more than 45. If dog has long hair, you need to separate dog hair to make electrodes touched.
  3. Remote/Receiver does not response
    Recharge the Remote/Receiver,make sure they have enough power. Check the keypad lock(which is on the left side of Remote), unlock the Remote. If Remote is locked, there will be a lock icon on the display. If you try methods above but still fail, please remove all the matching and reconnect Remote with Receivers.
  4. Receiver is fully charged, but Remote
    Display still shows receiver has empty battery. Turn off Remote and turn on Remote again.
  5. Fail to match Receiver with Remote
    Make sure Receiver is connected to a power source( charging mode can only be activated while charging). Must hold Channel Switch more than 5 secs, if not,
    matching will fail. If you still fail after trying as above, contact us via
    support@dogcareglobal.com to confirm whether receiver and remote is of the different version, we will solve for you.
  6. Training mode fails to sync up even in a very
    short distance Make sure there is no strong signal interference in your surroundings. Remote’s range could

X. Operating Environment & Maintenance

Do not use the product in the circumstances as follow:

  1. Do not operate the devices under temperature of 104°F and above, doing so in such high temperature will decrease the performance of the batteries.
  2. Do not use the Remote during snowing, this could lead to water sipping in causing damage to the controller.
  3. Do not use the set in places with strong electromagnetic interference. This will greatly compromise the performance of the product.
  4. Avoid dropping the devices on hard surface inflict excessive force on them.
  5. Avoid using the devices in environment flooded with corrosive chemical, this may lead to color degrading, deforming, or cracking of exterior of the devices.
  1. When not in use, please wipe clean both the Remote and Receiver with mild detergent. Turn off the Remote, lock the keypad, put on port, the rubber lid on the Receiver’s charging and store the set in a cool dry place.
  2. During cleaning, wipe with soft cloth and mild detergent. Do not use hard brushes which may scratch the surface of the device.
  3. If the Receiver has gotten dirty, secure the charging port rubber lid secured and W

XII. Product Specification

XII. Product Specification

If any quality problems or confusion, feel free tocontact us
support@dogcareglobal.com

Questions about your Manual? Post in the comments!

Leave a comment

Your email address will not be published. Required fields are marked *