Digilog Electronics D32133 LED Controller User Manual

Digilog Electronics D32133 LED Controller

Recommended Tip: Try not to bend at electronic components like the light pad to avoid a short circuit.

Remote

Pairing Instructions

1. Download the APP and install on your phone.
2. Turn on the Bluetooth on your phone.
3. Open the APP, tap the “+” icon in the top right corner and search new device.
4. APP will show the device found, just add it.
5. Tap the device icon to enter control panel.

Tips and Cautions

1. Use the product with the provided power adapter and control box only.
2. Unroll the strip light before powering on.
3. Do a power-on test before installation.
4. Pull out the transparent sheet from IR remote before using.
5. Be cautious of static electricity during installation and usage.
6. Do NOT allow children to install the strip light alone.
7. Please turn off the power and unplug the adapter if the strip light will not be used for a long time.
8. Keep the product away from sharp objects or strong corrosive chemicals.
9. Please do NOT connect more strips to the product which will cause the power adapter overload.
10. Adjust mic sensitivity and the distance between sound source and the phone/device mic in Music Mode to get the best music sync effect.
11. Please contact us if you have any problems or get a defective product. We will reply within 24 hours.

INFORMATION TO THE USER

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency enerv and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to fry to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following tvvo conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.