DETIKO QJ01-A1 3MP Wireless Security Camera with Solar Panel

Product Description

1. Solar panel
2. Antenna
3. Indicator light
4. PIR sensor
5. White light/infrared light
6. Photoresistance
7. Lens
8. Microphone

Overview

Indicator lights status

NOTE: The device is hibernating, and the indicator light turns off. To check if the device is powered on, click the reset button to see if the indicator light is on.

Button Controls

Equipment installation

• The wall should be with enough thickness to bear at least three times weight of the device.
  1. Take out the bracket and accessories, Choose a proper installation location, and make holes according to the positioning sticker. Install the rubber plug and tighten the screws to firm the bracket.

     

  2. Press the device forward and fix it on the bracket, then install the solar panel set after finishing installing of the device.

     

• Solar panel Please choose a proper location without any shadows and have sufficient sunlight. After installation, you can use the device after inserting the Type-C plug into the device Type-C interface.

Documents / Resources

DETIKO QJ01-A1 3MP Wireless Security Camera with Solar Panel [pdf] Installation Guide QJ01A1, 2BLM8-QJ01A1, 2BLM8QJ01A1, QJ01-A1 3MP Wireless Security Camera with Solar Panel, QJ01-A1, 3MP Wireless Security Camera with Solar Panel, Wireless Security Camera with Solar Panel, Security Camera with Solar Panel, Camera with Solar Panel, Solar Panel, Panel, Camera

References

• User Manual